Search the forum,

Fuel pump voltage at 80volts

Discuss Fuel pump voltage at 80volts in the Oil and Solid Fuel Forum area at PlumbersForums.net

D

Dave hall

Hi, just fitted a new fuel pump and control unit to my ecotherm boiler but I still can’t get any fuel to the top of the pump, nothing coming out of the bleed screw but definitely fuel in the bottom of the pump. I checked the voltage to the pump and it’s only 80volts but there is 240volts going into the control unit.
Any ideas
 

Reply to Fuel pump voltage at 80volts in the Oil and Solid Fuel Forum area at PlumbersForums.net

Similar plumbing topics

F
Mystery Mira Elite QT Leak
Hi All I have a leak coming from within my Mira Elite QT shower. It seems to be flowing from behind the switching Control. Any ideas what could be causing this leak. Already Changed the Pump Elbow as one of the clips had popped which was causing a second small leak, Any idea? Is it time to buy...
Replies
0
Views
221
Firefox
F
D
UK Can't get stopcock 100% closed to allow a tap repair
I have a plumber coming tomorrow to change a cartridge on a badly dripping tap on my bathroom mixer unit. There is no separate isolating valve for this tap so I'll have to close the stopcock. I tried closing it today but it won't go absolutely 100% closed and there is still a very slight flow...
Replies
1
Views
228
Chuck
C
C
Mixer bar fitting solutions?
The fittings below are for a mixer bar attached to a self contained shower. i.e not a wall. The attaching screws have snapped. I could get two new brackets, dismantle that existing one and start again or I could try and re attach via those screws, removing the broken ones from the plate and wall...
Replies
1
Views
162
SimonG
SimonG
sammie81116
Sewer pipe problems not sure about it
Hi all Noticed bad smell in my drain out side put my hand down and it unclogged it for now however I checked my sewer drain and after flushing my toilet a good few times nothing is going to the sewer so don't know is there a blockage or what way it works many thanks and advice would be grateful
Replies
3
Views
463
Chuck
C
johndave
Outdoor stopcock doesn't fully close
Hi all I'm hoping someone can shine a light on this for me Since our stop tap on the pavement has now been filled with sand for whatever reason, we are relying on our property fitted stopcock (this is outside on our garage wall) Unfortunately turning this to the closed position only reduces...
Replies
3
Views
224
exedon2
exedon2
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock