Search the forum,

For sale. Vaillant Commercial Boiler Flue Elbows and Extension. Any offer considered

Discuss For sale. Vaillant Commercial Boiler Flue Elbows and Extension. Any offer considered in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
V

Vee

Plumbers Arms member
Plumber
Gas Engineer
Subscribed
Messages
427
I have two 0.5m long extensions and two pairs of 45 degree bends for Vaillant Commercial Boilers. Internal 110mm and external 160mm diameter. Offers invited. Located in North East Hampshire j4a off M3.
 
Status
Not open for further replies.

Reply to For sale. Vaillant Commercial Boiler Flue Elbows and Extension. Any offer considered in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

F
Mystery Mira Elite QT Leak
Hi All I have a leak coming from within my Mira Elite QT shower. It seems to be flowing from behind the switching Control. Any ideas what could be causing this leak. Already Changed the Pump Elbow as one of the clips had popped which was causing a second small leak, Any idea? Is it time to buy...
Replies
0
Views
207
Firefox
F
B
POTTERTON PROMAX 28 COMBI Boiler - Hot Water Issue
Hello, I am seeking some advice, I have a POTTERTON PROMAX 28 COMBI Boiler and I noticed yesterday that the water around the house is no longer warming up. The heat exchanger has been changed 6 months ago, so I do not believe it is that. Does anyone have any ideas on what it could be? Thanks
Replies
4
Views
167
oz-plumber
O
W
Outdoor Tap at Porch
Hi, basic question, any insight much appreciated. Looking to have an outdoor tap in my front porch fed from 15mm pex coming up from suspended floor. Pic 1 is inside porch, pex temporarily clipped to give an idea of pipe placement (ignore shoddy blockwork of booted cowboy builder!), Pic 2 is...
Replies
6
Views
202
Dave Moore
D
P
LCS to new water mains
Hi, I have an old steel water mains pipe (approx 45mm) that I need to connect to a new pehd water mains (25mm). I can't get at it to create a new thread so what's the best way of connecting the two? Cheers, Peter
Replies
2
Views
160
ShaunCorbs
ShaunCorbs
dreikher
Hole in copper pipe, solder under floor, T coupling & protection
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Replies
0
Views
120
dreikher
dreikher
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock