Search the forum,

"Fluxuator" electrical tool for fluxing pipes

Discuss "Fluxuator" electrical tool for fluxing pipes in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
R

Ric2013

Plumbers Arms member
Plumber
Messages
3,909
Anyone seen the adverts for this in Installer magazine?

It reminds me of the Betterware hammer that had a hollow handle and dispensed the nails to make driving nails a one-handed job. Which I also didn't buy.
 
Status
Not open for further replies.

Reply to "Fluxuator" electrical tool for fluxing pipes in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

P
Viessmann combi starts when cold, mixer, tap is opened
Recently had a Viessmann Vitodens combi boiler installed, quite often when the adjacent cold mixer tap is opened the boiler starts for a few seconds! Can anyone tell me what is causing this? And how to cure?
Replies
3
Views
178
ShaunCorbs
ShaunCorbs
F
Mystery Mira Elite QT Leak
Hi All I have a leak coming from within my Mira Elite QT shower. It seems to be flowing from behind the switching Control. Any ideas what could be causing this leak. Already Changed the Pump Elbow as one of the clips had popped which was causing a second small leak, Any idea? Is it time to buy...
Replies
0
Views
202
Firefox
F
jamespipe
Plumber recommendation for heat pump HWS installation
Hi, My current hot water system needs to be replaced. Anyone got any suggestions or can recommend any plumbers around Derrimut area that won't rip me off? An office guy recommended me to apply for government rebates and get it installed through timetosave.com.au. How reliable is this...
Replies
4
Views
183
oz-plumber
O
T
22mm MDPE connection
I want to reconnect some outbuildings to an existing water supply. The supply pipe is old 22mm MDPE and buried for a fair distance so not going to dig it up and replace it šŸ˜¬. Question is can I use normal 22mm plumbing push-fit connectors to make the connection as finding 22mm MDPE fittings...
Replies
1
Views
206
ShaunCorbs
ShaunCorbs
C
Mixer bar fitting solutions?
The fittings below are for a mixer bar attached to a self contained shower. i.e not a wall. The attaching screws have snapped. I could get two new brackets, dismantle that existing one and start again or I could try and re attach via those screws, removing the broken ones from the plate and wall...
Replies
0
Views
108
ChrisGid
C
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock