Search the forum,

Discuss Firebird riello rdb burner in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Inverness

Plumbers Arms member
Plumber
Gas Engineer
Messages
710
My burner keeps cutting out it will run for maybe an hour or longer then cuts out but when you hit the reset button it starts again and runs no problem for another period of time.
I can hear a slight crunchy sound possibly coming from the oil pump..
 
A few days ago there was a high pitch whining noise coming from the boiler. I have never changed a riello control box before. I have a old riello spare burner I can swap over the control box?
 
Simple as this, - turn oil off, remove oil pump and then refit burner and turn it on and off for a few seconds while listening carefully.
If you hear any roughness, the motor bearing are gone and need replaced.

If not, then oil pump is probably worn inside and if you really wanted to verify that, the pump can be taken apart to view the gears and drive pin.

How old is the pump? 8 or 10 year old very likely worn
 
Could be anything as Best has said above. Intermittent lockouts like that would prompt me to check capacitor rating (anything below 70% of original value I was told to replace as can cause this problem) check for tight spot on pump and wether motor bearings are starting to stick. A fan could be too close to fan housing causing a tight spot but unless has been touched I wouldn’t of thought? Control box could be the answer as could a couple other things but really I would want to be at the burner when it goes to lock out to see/hear exactly what’s happening.
 

Reply to Firebird riello rdb burner in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

Hi, Can anyone advise as to why the cold water to my bathroom keeps airlocking? This originally happened about 12 months ago and has happened 3-4 times since. It’s an upstairs bathroom, fed from a tank in the attic. The tank is about 8 Meters away and feeds a bath, sink and toilet. The tank...
Replies
9
Views
305
Hi All I have a leak coming from within my Mira Elite QT shower. It seems to be flowing from behind the switching Control. Any ideas what could be causing this leak. Already Changed the Pump Elbow as one of the clips had popped which was causing a second small leak, Any idea? Is it time to buy...
Replies
0
Views
225
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Replies
0
Views
175
We run a community village hall and have a large kitchen provided for the use of hirers. This includes a Lincat SLR9 gas cooker which I believe is a 23.8Kw appliance with all six burners and oven on max. This was installed some 10 years ago and has passed all subsequent Gas Safety inspections as...
Replies
4
Views
386
Hi, basic question, any insight much appreciated. Looking to have an outdoor tap in my front porch fed from 15mm pex coming up from suspended floor. Pic 1 is inside porch, pex temporarily clipped to give an idea of pipe placement (ignore shoddy blockwork of booted cowboy builder!), Pic 2 is...
Replies
6
Views
218
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock