Search the forum,

Discuss F1 Problem on an Ideal logic 24 combi in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
Messages
5
Hi

My ideal boiler (24) was fitted as a used swap (from a 35) a few weeks ago and the engineer is now ignoring me.

It shows F1 and when I top it up (to 1 bar) it works fine for a couple of hours.

It then spits water outside to release the excess pressure I guess, then it shows F1 and I refill to 1 bar

There are no other leaks.

I would appreciate feedback please.

thanks
 
if its new get ideal out also if its spirting out side thats not good dont put any more water in eg refill
 
You have had a used boiler fitted?
 
You need to get a gas safe engineer out to look at it.
(Probably best not to use the person who fitted it)
 
You must not fit that yourself and need to get an engineer in to replace.
 
Closed please get a pro in
 
Status
Not open for further replies.

Reply to F1 Problem on an Ideal logic 24 combi in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Creating content since 2001. Untold Media.

OFFICIAL SPONSORS

OFFICIAL SPONSORS

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock