Search the forum,

Discuss EN417 to 1" UNEF Propane Convertor? in the Plumbing Tools area at PlumbersForums.net

Messages
38
I bought a torch a few years ago that uses EN417 butane/propane cylinders.

As someone who only uses a torch now and again, the torch has been fine on smaller copper pipe but struggles on 22mm, especially in the cold.

I have seen an adaptor by Monument (437a) which I think should allow me to run Propane or even Mapp cylinders which would give me the extra heat...

Given I like the actual torch and the adaptor is only about £15 which is considerably cheaper than buy a new torch, is there any reason not to go down this route?

Thanks in advance,

Peter
 

Reply to EN417 to 1" UNEF Propane Convertor? in the Plumbing Tools area at PlumbersForums.net

Creating content since 2001. Untold Media.

OFFICIAL SPONSORS

OFFICIAL SPONSORS

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock