Search the forum,

Discuss dripping tap in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.

wanttolearn

Gas Engineer
Messages
100
received_10205299278430423.jpg
My mate got a problem with his tap constantly dripping as i got a lot to learn and never worked on one of these before is it just a rubber washer that needs replacing.
If so is it just undo the cap and replace washer from hot and cold or is it the handle that chooses the direction of water to shower head or taps.
Any info would be great thanks
 
Remove tap heads & shroud... You can then undo the brass nut.... Check washers & replace also shine a torch onto where the washer sits & check there are no pits on the face if so you gotta regrind a new face with a tap reseating tool.
 
The cold water probably tank fed, so CWS tank needs isolating for both hot & cold.
 
Status
Not open for further replies.

Reply to dripping tap in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Creating content since 2001. Untold Media.

OFFICIAL SPONSORS

OFFICIAL SPONSORS

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock