Search the forum,

Discuss Cracked top part of trap in shower in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Hi I have just bought a house and have just noticed a crack in the shower trap ,top part that connects to the tray.
There is no access to underneath of the shower tray.
Anyone identify the trap ? And can I replace the top part without having to remove the tray .
Thanks

20190423_171248.jpg
 
With access below the tray it's fairly easy to replace. Just looks like a standard mcalpine shower tap
https://www.NoLinkingToThis/p/mcalpine-shower-trap-white-40mm/5075v
If you have no access then as above, a small hole in the ceiling below, can easily be filled sanded and repainted so you won't notice, or remove the floor next to the tray so you can reach your arm under to hold the trap.
However, if your feeling brave, you could unscrew the top part and if the waste is supported or sealed to the underside of the tray then you could replace the top part with minimal fuss. Just be warned that it doesn't always work and if your not prepared to remove the ceiling if it goes wrong, don't try it.
 
Have done that a fair few times with success, takes a lot of patience and no silicone to hold it underneath, just a lot of feffin and jeffin. :)
HI
I have the same problem, top crack on shower trap and large stone slab and no access underneath. Did you remove the trap from above or try to seal the crack?
Thank
 

Reply to Cracked top part of trap in shower in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

The fittings below are for a mixer bar attached to a self contained shower. i.e not a wall. The attaching screws have snapped. I could get two new brackets, dismantle that existing one and start again or I could try and re attach via those screws, removing the broken ones from the plate and wall...
Replies
1
Views
153
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two hole mixer but the cold water pressure is high mains fed and the hot is low pressure immersion tank fed. I've been trying to find info on what I...
Replies
0
Views
42
Hi All I have a leak coming from within my Mira Elite QT shower. It seems to be flowing from behind the switching Control. Any ideas what could be causing this leak. Already Changed the Pump Elbow as one of the clips had popped which was causing a second small leak, Any idea? Is it time to buy...
Replies
0
Views
218
Hello all, I'm would like to extend an existing outside tap to another point in the garden. I'm about to pour a concrete patio and was hoping to run the water line underneath. There are existing drain (and who knows what) pipes running along the same wall so I'm nervous about digging too far...
Replies
6
Views
195
Hello, I am seeking some advice, I have a POTTERTON PROMAX 28 COMBI Boiler and I noticed yesterday that the water around the house is no longer warming up. The heat exchanger has been changed 6 months ago, so I do not believe it is that. Does anyone have any ideas on what it could be? Thanks
Replies
4
Views
207
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock