Search the forum,

Conventional boiler does not complete full cycle.

Discuss Conventional boiler does not complete full cycle. in the Central Heating Forum area at PlumbersForums.net

B

biswachk_deep

Conventional boiler does not complete full cycle, stops after an hour or so - room temperature set to 22 degree and water temp set to 65degree. But, neither water nor room temperature reaches to the max level. If I switch off the water controller then heating completes full cycle. Not sure, what is the issue - this issue happening intermittently.
Honeywell controller is st699.
 

Reply to Conventional boiler does not complete full cycle. in the Central Heating Forum area at PlumbersForums.net

Similar plumbing topics

B
POTTERTON PROMAX 28 COMBI Boiler - Hot Water Issue
Hello, I am seeking some advice, I have a POTTERTON PROMAX 28 COMBI Boiler and I noticed yesterday that the water around the house is no longer warming up. The heat exchanger has been changed 6 months ago, so I do not believe it is that. Does anyone have any ideas on what it could be? Thanks
Replies
4
Views
209
oz-plumber
O
johndave
Outdoor stopcock doesn't fully close
Hi all I'm hoping someone can shine a light on this for me Since our stop tap on the pavement has now been filled with sand for whatever reason, we are relying on our property fitted stopcock (this is outside on our garage wall) Unfortunately turning this to the closed position only reduces...
Replies
3
Views
221
exedon2
exedon2
P
Repeated Airlock in Bathroom
Hi, Can anyone advise as to why the cold water to my bathroom keeps airlocking? This originally happened about 12 months ago and has happened 3-4 times since. It’s an upstairs bathroom, fed from a tank in the attic. The tank is about 8 Meters away and feeds a bath, sink and toilet. The tank...
Replies
9
Views
297
Chuck
C
D
Extending outdoor tap and drain
Hello all, I'm would like to extend an existing outside tap to another point in the garden. I'm about to pour a concrete patio and was hoping to run the water line underneath. There are existing drain (and who knows what) pipes running along the same wall so I'm nervous about digging too far...
Replies
6
Views
205
DIwhYdidIstartThis
D
dreikher
Hole in copper pipe, solder under floor, T coupling & protection
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Replies
0
Views
165
dreikher
dreikher
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock