Search the forum,

Discuss connecting to 3" cast iron tee in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.

unguided1

Plumbers Arms member
Plumber
Gas Engineer
Messages
1,986
I have been to a job today where there is a 4" cast iron soil stack with a 3" branch, running inside a boxing inside the property. The person who has installed the new bathroom suite, has put the 42mm bath waste into the 3" branch and then loaded it up with plumbers mate, this is now leaking.
Does any body know of any fittings that I might use to get the 42mm waste pipe in to the 3" cast iron collar.
regards
Mike
 
Hi Get a 2" or 1/2" galv socket and caulk into socket, the a plastic to BSPT male adapter. Screw it in and connect plastic pipe. Good Luck
 
nice one justlead just the job I will let you know how I get on
Regards
Mike
 
Timesaver would mean cutting the collar off, but if you did decide to go that route
I suspect Fernco make a rubber fitting that will do it in one go
 
Status
Not open for further replies.

Reply to connecting to 3" cast iron tee in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Creating content since 2001. Untold Media.

OFFICIAL SPONSORS

OFFICIAL SPONSORS

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock