Search the forum,

Discuss Cold Radiators Downstairs in the Australia area at PlumbersForums.net

Messages
8
Hi, I've had this problem for a while. I have a fully pumped system with 3 way divertor valve. I have hot water and hot radiators upstairs. All radiators downstairs are cold (6 rads). A new pump was fitted, I have flushed the system with Sentinel X800 and X400. Also power flushed system. Recently drained down system again, flushed all radiators and opened all valves which flowed freely with hot on oneside and luke warm on other. Fitted a magnetic Boiler Mag filter, refilled system and still hot radiators upstairs but cold downstairs. If there is a solid plug of magnetite in pipes between upstairs and down stairs, how come the water flows freely from both hot and cold feed, but as soon as radiators refilled no heat?
 
Have you tried turning all the radiators that get hot off upstairs ? to see if the pump can move any trapped air in the downstairs rads ? you can even turn all but one of them off and see if any heat comes through then work through one by one till they all get hot, air is a funny thing and often hard to remove especially in a open vented system the pump may need venting ? you can normally hear air traveling through the system at the pump position if this is the case . Kop
 
Have you tried turning all the radiators that get hot off upstairs ? to see if the pump can move any trapped air in the downstairs rads ? you can even turn all but one of them off and see if any heat comes through then work through one by one till they all get hot, air is a funny thing and often hard to remove especially in a open vented system the pump may need venting ? you can normally hear air traveling through the system at the pump position if this is the case . Kop
Thanks I’ll give that a try today
[automerge]1572765773[/automerge]
Thanks I’ll give that a try today
 
Have the downstairs radiators ever worked properly?
Yes. It’s a Potterton Neta Heat boiler and the whole system worked perfectly until a couple of years ago when I started having problems after summer period when central heating was turned on. Hot water runs all year but during summer when C/H not needed thermostat turn right down. It used to work after leaving C/H running for a few hours as if it cleared itself
 
Have you checked the thermostatic valves pins are not jammed down? If your down stairs are on drops you might find you have to close the hot ones off upstairs and open each one down stairs in succession and close when hot until they all heat.
 
Have you checked the thermostatic valves pins are not jammed down? If your down stairs are on drops you might find you have to close the hot ones off upstairs and open each one down stairs in succession and close when hot until they all heat.
TRVs are all open as tops removed and pins up. Now got upstairs valves shut off. Pump set to full on and boiler turned up to high. Now getting some heat to 2 small radiators downstairs. Leaving it on for as long as possible with hope it will start to clear blockage
 

Reply to Cold Radiators Downstairs in the Australia area at PlumbersForums.net

Similar plumbing topics

Every two weeks or so I have to go and top up the system because the hot taps are running cold. Boiler display is flashing 0.6 bar and I fill up to 1.3. I've had an engineer look inside the boiler and he can't see anything wrong. I've checked the pipes all over the house and cannot see any...
Replies
1
Views
96
  • Question
Ideal Logic 24, Previous problem was that the hot water was only cold or barely warm if the heating was in use. If heating was off and boiler cold then would get hot water most of the time. Changing the flow cartridge about 2 years ago (when I moved in) solved this problem enough to suffer it as...
Replies
2
Views
95
Hi, Can anyone advise as to why the cold water to my bathroom keeps airlocking? This originally happened about 12 months ago and has happened 3-4 times since. It’s an upstairs bathroom, fed from a tank in the attic. The tank is about 8 Meters away and feeds a bath, sink and toilet. The tank...
Replies
9
Views
305
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two hole mixer but the cold water pressure is high mains fed and the hot is low pressure immersion tank fed. I've been trying to find info on what I...
Replies
2
Views
73
Hi all I'm hoping someone can shine a light on this for me Since our stop tap on the pavement has now been filled with sand for whatever reason, we are relying on our property fitted stopcock (this is outside on our garage wall) Unfortunately turning this to the closed position only reduces...
Replies
3
Views
230
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock