Search the forum,

Changing a Grohe cartridge

Discuss Changing a Grohe cartridge in the USA area at PlumbersForums.net

G

Geoffrey66

Messages
2
Good morning,

I am trying to change the cartridge on my Grohe Allure 32757000 Bathroom sink. I have removed the rubber grommet and the 3mm grub screw in the lever handle. According to the Grohe instructions and relevant YouTube video the handle should now simply pull up and off. Mine is not budging an inch. I wonder if anyone has any come across this problem before and if there is an easy solution, please.

Thank you very much.

Regards,
Geoffrey
 
Pour some hot ( but not boiling ) water over the handle.
Wait a minute or so for the heat transfer and then try to lift it off.

Thay can be quite stubborn at times
 

Reply to Changing a Grohe cartridge in the USA area at PlumbersForums.net

Similar plumbing topics

D
UK Can't get stopcock 100% closed to allow a tap repair
I have a plumber coming tomorrow to change a cartridge on a badly dripping tap on my bathroom mixer unit. There is no separate isolating valve for this tap so I'll have to close the stopcock. I tried closing it today but it won't go absolutely 100% closed and there is still a very slight flow...
Replies
1
Views
227
Chuck
C
C
Mixer bar fitting solutions?
The fittings below are for a mixer bar attached to a self contained shower. i.e not a wall. The attaching screws have snapped. I could get two new brackets, dismantle that existing one and start again or I could try and re attach via those screws, removing the broken ones from the plate and wall...
Replies
1
Views
151
SimonG
SimonG
P
Repeated Airlock in Bathroom
Hi, Can anyone advise as to why the cold water to my bathroom keeps airlocking? This originally happened about 12 months ago and has happened 3-4 times since. It’s an upstairs bathroom, fed from a tank in the attic. The tank is about 8 Meters away and feeds a bath, sink and toilet. The tank...
Replies
9
Views
277
Chuck
C
dreikher
Hole in copper pipe, solder under floor, T coupling & protection
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Replies
0
Views
156
dreikher
dreikher
johndave
Outdoor stopcock doesn't fully close
Hi all I'm hoping someone can shine a light on this for me Since our stop tap on the pavement has now been filled with sand for whatever reason, we are relying on our property fitted stopcock (this is outside on our garage wall) Unfortunately turning this to the closed position only reduces...
Replies
3
Views
209
exedon2
exedon2
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock