Search the forum,

Discuss Bosch CDI 30 combi boiler in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Messages
3
Hi, my boiler has been having an intermittent fault no one can seem to cure. When the hot tap is used , usually first time in the morning, it creates the boiler to over heat. I have to wait for it to reset itself and cool down then usually ok. Apparently not heat exchange plate.
 
Only advice you’ll get my friend is a gas safe engineer we will not provide any advice on diy boiler repairs
 
Fixed price repair then from Worcester if he doesn’t know

Sorry but we don’t give gas repair advice out unless your qualified
 
Hi, my boiler has been having an intermittent fault no one can seem to cure. When the hot tap is used , usually first time in the morning, it creates the boiler to over heat. I have to wait for it to reset itself and cool down then usually ok. Apparently not heat exchange plate.
Where are you based?
 
Thanks. I have so far spoken to my heating engineer who services my boilers and he said no point in coming out until it completely stops working. Also a plumber who was recommended and I have to say is very good. He came out and said very difficult with an intermittent fault but after phoning Bosch tried their advice but to no avail. I have spoken to other engineers who all are not sure what it could be. Meanwhile I have a boiler the every time we go to have a shower in the morning bangs and shows U9 then slowly drops in temperature until it starts up again. Then it tends to work OK. Not great when it services our house and attached holiday let. Just want it fixed
 

Reply to Bosch CDI 30 combi boiler in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

Hi, I have a Worcester Bosch Greenstar 30Si combi boiler, the analog clock has stopped and the On-Timer-Off switch only works on Timer setting,. So I have set all the little timer switches to ON and the boiler does work then. Any help or source for a new clock would be great. TIA
Replies
4
Views
235
Greetings. I have an external Worcester Bosch Heatslave boiler and have a question about pressure. The boiler pressure was set to 1.5 during a recent visit by a plumber (as it seemed to have dropped and was hovering between the green and red zone) . A few days later I turned the thermostat down...
Replies
4
Views
495
Greetings. I have an external Worcester Bosch Heatslave boiler and have a question about pressure. The boiler pressure was set to 1.5 during a recent visit by a plumber (as it seemed to have dropped and was hovering between the green and red zone) . A few days later I turned the thermostat down...
Replies
4
Views
404
My first thought when I heard this fault a combi boiler with hot water but no heating. Was a problem with the stat, controls not making the call for heat. If this is not the case. Can the divertor valve be the cause of the issue?
Replies
0
Views
328
Hi Folks, I have a challenge with a Main Eco Elite 30 Combi which is short cycling on the CH. Water works fine. As soon as you have call for heat, the boiler fires up, modulates, but jumps very quickly (about 30 seconds or so from 40'ish all the way to 70, burner disengages putting it the...
Replies
6
Views
364
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock