Search the forum,

Discuss Baxi boiler needs topping up daily in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Messages
6
Hi, we've got a Baxi Combi 105 HE boiler which is about 13 years old. It needs water adding every time I put it on as it keeps dropping 0. I was going to nurse it through another winter but I'm thinking things must be dire now. How much would a like for like replacement be with fitting, a guesstimate?
 
It my need a service. Have an engineer come out and service boiler and explain about the pressure loss. Most will be on the part that is causing it straight away and should be checked as part of the service, If it continues after that you may have a leak on the heating system.
 
Check the p.r.p. out side see if it is dripping when boiler has been on for 10 mins.
Small copper pipe outside
 
Evening @Ban70. This could be a number of things, from a large leak on the system, to a part failure on the boiler. Can you top the pressure up to just above 1 bar and put the heating on please. Can you then watch the pressure and see if it rises to above the 3 bar on the pressure gauge.

Please like this post if you found it helpful.
 

Reply to Baxi boiler needs topping up daily in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

Hi all,new to the forum and hoping to get some guidance through the boiler minefield . We moved into a 70s bungalow last Feb,its got a Greensted 241 junior mark 3. The expansion tank has failed, also it has a Boss therm sender unit wired to it but the previous owner didn't leave the receiver...
Replies
9
Views
427
Hi I have a baxi duotec combi boiler that every day or other day needs topping up as pressure drops below 0.5bar. When fired up it can reach OVER 2.5bar also whilst running CH. Is this more than likely a flat Expansion Vessel that needs inflating or could there be other possible causes if...
Replies
2
Views
345
Hi, I'm hoping someone here may be able to help me out with an issue I have with my baxi duotec boiler. Basically, the hot water temperature has been fluctuating quite alot, dropping in temp then raising again whilst showering. I have had an engineer out who has changed the thermistor, but I am...
Replies
5
Views
410
M
Hi, we have a back combi heater. Whenever the heating comes on it seems to lose pressure within a few hours and I have to refill each morning. The boiler seems to function well, and the pressure only drops with the heating and not the water being on. Ie it started last winter and was then...
Replies
1
Views
366
During an install of new boiler ('old' boiler died after 11-12 years) the system was "drained" but I guess maybe 90% of water was left in the (rather large) underfloor pipe system. What is the best way to tell how much inhibitor should be added in this case? (also taking account that system was...
Replies
2
Views
274
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock