Hi, about 3 weeks after overhauling the diverter and diff valves with valve and seal kit, the noise started to occur seemingly from the diverter although it's difficult to pinpoint exactly. The noise starts a few minutes after CH is activated, and is persistently loud and is carried through pipework to radiators. Opening a hot water tap stops the noise immediately only to return a minute or so later. Also, fully opening all trv's stops the noise, very significantly but not entirely. Any advice is very welcome and appreciated.
Discuss Baxi 105e screeching/whining in the Central Heating Forum area at PlumbersForums.net
Reply to Baxi 105e screeching/whining in the Central Heating Forum area at PlumbersForums.net
Similar plumbing topics
Hi, basic question, any insight much appreciated.
Looking to have an outdoor tap in my front porch fed from 15mm pex coming up from suspended floor. Pic 1 is inside porch, pex temporarily clipped to give an idea of pipe placement (ignore shoddy blockwork of booted cowboy builder!), Pic 2 is...
- Sticky
Morning to any Australians lurking around! Register its free, then message me, I'll sort your account out for you. We will need a moderator from each main country too.
I'll post this in the Australian forum now.
Creating content since 2001. Untold Media.
Newest Plumbing Threads
-
Trying to source a dual-flush valve
- Started by Thomas J Marshall
- Replies: 2
-
-
-
-
What constitutes a Commercial Appliance and thus a Commercial Kitchen?
- Started by FozzieBear
- Replies: 3
-
POTTERTON PROMAX 28 COMBI Boiler - Hot Water Issue
- Started by boiler101
- Replies: 4
-
Hole in copper pipe, solder under floor, T coupling & protection- Started by dreikher
- Replies: 0
-
-
-
-
-
-
-
-