Search the forum,

Bath mixer tap identification

Discuss Bath mixer tap identification in the USA area at PlumbersForums.net

G

Greyman

Messages
2
Bath mixer tap manufacturer identification

I have a drip on the cold side of my quarter turn bath mixer. I cant isolate the feed as the isolation valves were installed face down
against the floor!
If some kind soul could identify the make/manufacturer I could source a new cartridge. My guess is the mixer is approx 15 years
old. Image attached.

Thank you
 

Attachments

  • 20220110_121738.jpg
    20220110_121738.jpg
    199.4 KB · Views: 12
  • 20220110_121645.jpg
    20220110_121645.jpg
    403.6 KB · Views: 12
  • 20220110_121627.jpg
    20220110_121627.jpg
    321.6 KB · Views: 12
Maybe grohe
 

Reply to Bath mixer tap identification in the USA area at PlumbersForums.net

Similar plumbing topics

S
Advice needed for a mixer Spray for kitchen ?
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two hole mixer but the cold water pressure is high mains fed and the hot is low pressure immersion tank fed. I've been trying to find info on what I...
Replies
2
Views
77
Lou
Lou
C
How to identify dripping tap.
Our kitchen mixer tap has started dripping. Like so much of the plumbing in our almost new build bungalow, it is lacking! The plumber didn't install any isolating cocks in the H&C feed to the tap so how can I identify which of the valves is passing? Shut the whole H&C water system down?
Replies
12
Views
314
Timmy D
T
D
UK Can't get stopcock 100% closed to allow a tap repair
I have a plumber coming tomorrow to change a cartridge on a badly dripping tap on my bathroom mixer unit. There is no separate isolating valve for this tap so I'll have to close the stopcock. I tried closing it today but it won't go absolutely 100% closed and there is still a very slight flow...
Replies
1
Views
233
Chuck
C
C
Mixer bar fitting solutions?
The fittings below are for a mixer bar attached to a self contained shower. i.e not a wall. The attaching screws have snapped. I could get two new brackets, dismantle that existing one and start again or I could try and re attach via those screws, removing the broken ones from the plate and wall...
Replies
1
Views
179
SimonG
SimonG
P
Repeated Airlock in Bathroom
Hi, Can anyone advise as to why the cold water to my bathroom keeps airlocking? This originally happened about 12 months ago and has happened 3-4 times since. It’s an upstairs bathroom, fed from a tank in the attic. The tank is about 8 Meters away and feeds a bath, sink and toilet. The tank...
Replies
9
Views
306
Chuck
C
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock