Discuss Anyone know what type of nut is needed for an Irwin pipe bender? in the Plumbing Tools area at PlumbersForums.net
Thanks very much, I'll get one of each!If Irwin can’t help, I doubt someone will know from memory.
You either need a tap/die set in m12 and then line up the different pitches to figure it out. Or if you don’t have a set, hope someone on here does and the same bender.
I’ve got the set, just not the bender.
I’d just order a nut for each pitch, there’s not many. Most common in m12 is coarse thread - 1.75 and fine thread - 1.25.
However, you can get 1.0, 1.5, 2.0 etc.
If you can’t test, find a thread that goes into the nut you have and then line it up with the bender thread. If you know your nut pitch, then you’ll know if you should go coarser or finer.
Or just order one of each I’ve listed.
Reply to Anyone know what type of nut is needed for an Irwin pipe bender? in the Plumbing Tools area at PlumbersForums.net
We get it, advertisements are annoying!
Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.