Search the forum,

Discuss A shameful secret to which i need advice... in the General Off-Topic Chat area at PlumbersForums.net

Jerry

Gas Engineer
Messages
328
Gentlemen,

Please excuse the troll title but I am sure you have all been there...

On your hands and knees, dripping in sweat. Panting and almost crying.
So you reach for the magic little tube that can solve those wet problems.
And then you are left feeling disgusted and with dirty sticky hands.

So.

How do you get LSX off your hands????
 
1. wonderwipes or similar
2. It's really soft, most of it'll rub off.
3. use less, itll block up valves etc if it gets inside the system
Washing hands for 10 mins will just make them raw, and who has 10 minutes to wash hands?
 
The old LSX does lend itself to being smeared by hand. I tend to rub off of as much as possible straigh after use with toilet paper then several hours later when its dry by rubbing affected area with another finger (usually while driving)
 

Reply to A shameful secret to which i need advice... in the General Off-Topic Chat area at PlumbersForums.net

Similar plumbing topics

Hi bit of a weird issue, I installed a grohe bathroom tap successfully 2 months ago bought from screwfix. Last week the right hand hot tap makes a squeak noise as I turn it on or off, left tap is 100% perfect and noiseless. This grohe tap is like one unit, so no screw notch or way I can remove...
Replies
1
Views
33
Our kitchen mixer tap has started dripping. Like so much of the plumbing in our almost new build bungalow, it is lacking! The plumber didn't install any isolating cocks in the H&C feed to the tap so how can I identify which of the valves is passing? Shut the whole H&C water system down?
Replies
12
Views
314
Hello, I am seeking some advice, I have a POTTERTON PROMAX 28 COMBI Boiler and I noticed yesterday that the water around the house is no longer warming up. The heat exchanger has been changed 6 months ago, so I do not believe it is that. Does anyone have any ideas on what it could be? Thanks
Replies
4
Views
212
Hi all. Hope you have all been keeping well. A while back I decided I only wanted to fit one brand of boiler and decided on Viessmann due to space for servicing and changing parts if ever needing to. I am finding my decision rather hard due to the different clearances on flue runs and cupboards...
Replies
9
Views
150
  • Question
Ideal Logic 24, Previous problem was that the hot water was only cold or barely warm if the heating was in use. If heating was off and boiler cold then would get hot water most of the time. Changing the flow cartridge about 2 years ago (when I moved in) solved this problem enough to suffer it as...
Replies
2
Views
91
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock