Search the forum,

Discuss 32mm non threaded sink trap in the Plumbing Forum | Plumbing Advice area at PlumbersForums.net

Messages
4
My sink and a half & pipework are 32mm in dimension. They look similar to this but the pipe coming down from the sink is only threaded at one end (the end connected to the sink).

How do I connect the non threaded end to the rest of my pipework?
 
Sink and half are normally 40mm / 1.1/2"

The ends in red are threaded to go onto the sink waste
The ends in green are plain and fit into a compression fitting with a seal and can be adjusted to get the height difference correct between sinks.


Sink waste.PNG
 
Looks like it’s dropped undo the nut and push it back up and tighten the nut up again
 

Reply to 32mm non threaded sink trap in the Plumbing Forum | Plumbing Advice area at PlumbersForums.net

Creating content since 2001. Untold Media.

OFFICIAL SPONSORS

OFFICIAL SPONSORS

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock