Search the forum,

viessman

Elections were held on November 2, 2010, to determine Missouri's nine members of the United States House of Representatives. Representatives were elected for two-year terms to serve in the 112th Congress from January 3, 2011 until January 3, 2013. Primary elections were held on August 3, 2010.Of the nine elections, the races in the 3rd and 4th districts were rated as competitive by The Cook Political Report, CQ Politics, The Rothenberg Political Report and Sabato's Crystal Ball. Seven of Missouri's nine incumbents were re-elected, while one (Ike Skelton of the 4th district) unsuccessfully sought re-election and one (Roy Blunt of the 7th district) did not seek re-election.In total, six Republicans and three Democrats were elected. A total of 1,920,675 votes were cast, of which 1,103,290 (57.44 percent) were for Republican candidates, 708,064 (36.87 percent) were for Democratic candidates, 92,485 (4.81 percent) were for Libertarian Party candidates, 8,759 (0.46 percent) were for Constitution Party candidates, 7,193 (0.37 percent) were for an independent candidate and 884 (0.05 percent) were for write-in candidates.

View More On Wikipedia.org
Recent contents Top users
  1. M

    Vitodens 200 (Viessman)

    I have this boiler to heat and provide hot water for my home. I have had a total of three of these boilers. The first two were recalled by Viessman and replaced. The problems with the recalled boilers was I had to keep replacing ionization and ignition electrodes. There was also some risk of...
  2. H

    tado wireless smart thermostat v3+ and viessman 100-W installation

    I have a Viessmann 100-w four pipe system boiler controlled by a Potterton EP2001. I have bought a Tado smart thermostat starter kit v3+ but can't find out how to wire it. I have seen mention of using a Tado extension kit but the Tado website says: Extension Kit The Extension Kit performs a...
  3. J

    Shunt pump control - Viessman boiler

    Having Viessman Vitodens 200-w 32kw installed. I’m expecting to then install low loss header and secondary pump for whole house. (Size / flow rate justifies this). I’m looking for 1) confirmation that the secondary pump will be controlled via (something like) their EM-M1 controller...
  4. I

    Viessman 4 pipe setup with zoning using OT

    I’m in the process of looking into the Viessman 4 pipe system to use with the Heatrae Sadia Megaflo and the Vitodens 100W system boiler I have. Currently, I have two Nests zoned for upstairs and downstairs, would I be able to use multi zone with the 4 pipe setup - would I then be able to use...
    • iconboy2021
    • Thread
    • america pipe setup usa using viessman zoning
    • Replies: 0
    • Forum: USA
  5. J

    Viessman vs Vaillant and Honeywell vs Tado vs Hive

    I am trying to help my dad decide with a boiler replacement, can't decide between Vaillant Ecotec Pro 30kw or Viessmann Vitodens 100 30kw. The boiler will be going in the exact same spot as before. Both will have a system cleanse, inhibitor and magnetic filter (I am not sure which brand or...
    • Justice League
    • Thread
    • america hive honeywell tado usa vaillant viessman
    • Replies: 4
    • Forum: USA
  6. S

    Viessman Vitodens 111 35kw

    Hi guys, I've recently had a loft conversion and decided to get a new bolier installed at the same time. My plumber decided to remove our tanked system in airing cupboard (this is where the stairs are now located) and to install a viessman Vitodens 111 35w combi up in the loft conversion...
  7. J

    Old Viessman vitodens 100 combi problems

    Hi guys, Just replaced some radiators in a recently purchased student let. The boiler is a 12 year old vitodens 100, 7248589. I tested the heating and hot water before draining down and it seemed to be working, maybe a little lack lustre on the heating. After completing the rads, refilling...
  8. A

    Looking for a Gas Safe engineer to install a Viessmann Boiler SE London

    Hi, i’m looking to upgrade my heating system; i currently have an unvented system with a Potterton Boiler, cylinder in the airing cupboard (1st floor). what i want to do is change the boiler to a Viessmann in a new position - cupboard at the front of the property - see pics. Also i want the...
  9. A

    Viessman Vitodesn 100 banging

    Hi guys, I have a Viessman Vitodens 100 heat only open vent boiler that was fitted around 4 years ago. It has been serviced when required and overall runs great and very efficient. However, at the end of last year we had an extension built and the flue had to be extended around 2 meters...
  10. J

    Plumber / Engineer wanted in Wirral with Viessman / Tado Experience

    I have now given up on my Viessmann accredited engineer. I need my Tado connecting to my KM Bus in the Boiler (presently on constant with no WC), so effectovly a wiring job. Furthermore I am looking for confimration that my boiler has been fitted correctly. My HW feed pipe on top of my...
  11. V

    Viessman boilers what do heating engineers think?

    Does anybody have any views as to whether Viessman boilers are any good. Just seen an advert on tv £16/month and 10 year guarantee. I currently pay more than that for my boiler cover with Corgi on my 8 year old Glowworm boiler. On the face of it it would pay me to get a new boiler and pay less...
  12. G

    Are viessmann 111 w boilers any good

    Veissmann 111 w has been suggested for a one bathroom two shower room installation. I've never fitted one before and I am looking for some advice. How good are these boilers, build quality, reliability etc. and what are Veissmann's like to work with for customer support. Any comments...
  13. N

    Glow worm Ultimate 120ff replacement recommendations, please

    Hi, My Glow worm Ultimate 120ff is dying - just started leaking from the heat exchanger, which I assume is terminal. I'm looking for a replacement regular boiler for my traditional, open-vented S plan installation, as 'like for like' as possible under current regs, with reliability and long...
    • nickS14a
    • Thread
    • boiler glow glow worm glow-worm installer please recommended replacement ultimate viessman wiring worm
    • Replies: 7
    • Forum: Plumbing Jobs | The Job-board
  14. A

    Viessman vitodens 100 on lpg

    Morning all. Boiler came up with F4 fault code. As per book could be one of half dozen issues! Things I have checked..... Condense is clear... Burner gauze clean..... Ionisation block replaced.... from boiler reset, the fan starts, after a few seconds a distinct click and gas valve opens...
  15. W

    Old Viessman 200 for free

    Pick up only, and if you can give me the best poem.:)
  16. F

    What are you views on Viessman 100wb1c

    My plumber has recommended the Viessman 100wb1c combination boiler. Having looked it up on some other review board, there seem to be a lot of complaints with a Viessman boiler as well as poor customer care from viessman. What are your thoughts on this boiler?
  17. F

    Weather Compensation

    Hi all, In our referbedhouse we are looking at 7 wet UFH zones and 6 rads upstairs. Am I correct inassuming that boiler weather compensation would have no effect on the UFH zonesas the temperature is mixed at the manifold. If myassumption is correct, it’s probably not something worth...
  18. K

    Viessman vitodens 100 problem

    Boiler had no hot water but heating, fault was diverter valve. Replaced that, now it fires on DHW however gets up to overheat and cuts out. Replaced the temp stat however didnt fix the boiler. The old stat probe was thick in sludge, phoned viessman, they recon its a circulation problem and...
  19. L

    viessman vitodens 100

    hi can anyone give me some advice . my vitodens 100 boiler keeps dropping water pressure . every 5 days it drops tp .5 bar and stops working . i have looked for any signs of leakage at the radiators but they look dry , i have had the boiler for 6 years and i can remember the viessman engineer...
  20. D

    Powermax 155 replacement

    Hi, I am quoting to replace a powermax for a vaillant 428 and megaflo and it comes out a bit pricey. A combi however big will not do. Does anyone have any suggestions for an alternative system, the main criteria is plenty of hot water to multiple outlets. Your suggestions would be appreciated.
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock