You are using an out of date browser. It may not display this or other websites correctly. You should upgrade or use an alternative browser.
slow
In everyday use and in kinematics, the speed (commonly referred to as v) of an object is the magnitude of the rate of change of its position with time or the magnitude of the change of its position per unit of time; it is thus a scalar quantity. The average speed of an object in an interval of time is the distance travelled by the object divided by the duration of the interval; the instantaneous speed is the limit of the average speed as the duration of the time interval approaches zero.
Speed has the dimensions of distance divided by time. The SI unit of speed is the metre per second (m/s), but the most common unit of speed in everyday usage is the kilometre per hour (km/h) or, in the US and the UK, miles per hour (mph). For air and marine travel the knot is commonly used.
The fastest possible speed at which energy or information can travel, according to special relativity, is the speed of light in a vacuum c = 299792458 metres per second (approximately 1079000000 km/h or 671000000 mph). Matter cannot quite reach the speed of light, as this would require an infinite amount of energy. In relativity physics, the concept of rapidity replaces the classical idea of speed.
Vaillant Ecotec Pro 28
Running 7 radiators.
Outside Tap Cold water flow rate = 12l/s (it took 5s to fill 1l pot)
Kitchen Tap - just running cold water = 4 l/s
Bristan Shower Mixer - cold water rate = 12 l/s Hot water rate is really low
The boiler heats up the water fine -its nice and hot...
Hi, I am new here and I need some help with a home repair.
I have this pipe located in my basement inside my wall made of concrete that is showing signs of water leaking onto my basement floor. There is no leaks from the pipe itself, the water is only coming from the bottom where the concrete...
Having a slight problem with the basin slow emptying. Plunnging it helps a little, i have taken the trap off and its clear, the pop up waste is clear, the waste runs into the internal soil stack, i think the issue is a flat run of the waste for about 2 meteres along the floor. I did ask the...
The cistern has been filling fine for nearly a year, then in the last week or so it has been taking ages to full.
Taking thr cover off the symphonic release is working and sealing fine upon completion. The float on the fill is working, but when it's filling their is a trickle and a fine spray...
The bathroom was refitted 10 years ago. Everything was fine until a couple of years ago. The basin is very slow draining and you can see the water coming up from the P trap and then filling up the basin. I've tried drain unblockers etc. and also put a hose with a snug fitting nozzle into the...
Hi,
I have today removed our bath ready to put a new one in and have capped both the hot and cold feeds off.
However, when putting both the hot water (turned off as cold feed on to the cyclinder) and cold water back on (turned off at both the stop tap under the sink and the cold feed in the...
I bought a new kitchen mixer tap. Link below.
https://www.wrenkitchens.com/aurora-tap-chrome-high-low-pressure/8901
Every time I walk into the kitchen, I see a drip on the end of the tap. I remove the drip, to discover another drip on the end of it after about couple of hours. Now, is there a...
I have a macerator which does a toilet, sink and shower in our basement, it has worked fine for 2 years then water started backing up into shower tray so I took the macerator out (3 hr job due to location) and the non-return valve had come a bit loose. Repaired that, gave it a good clean out...
Hi, does anyone know of a slow dry/cure solvent cement for ABS waste pipes please?
Got some 50mm floplast ABS waste pipes in a tricky ceiling that will be a pain to get the cement on, line up and push together before the normal solvent cement goes off - in the 15 seconds you get to fit them...
Hi there. Have a carron mixer tap in kitchen the flow on the hot tap side has become very slow for no apparent reason. To almost a trickle...was never like that previously.
Hot tap in bathroom.upstairs is strong.
When I remove the connection under the sink the flow seems good and strong but...
hi guys and girls need a bit of advice from a plumber or that, i fitted a new low shower tray and its draining very slow i have to switch off power shower to stop water getting close to the top of tray all i changed was tray it came with its own waste trap and connected it with flex pipe as...
Our Glow Worm 38cxi boiler is about 15 years old. When turning on the central heating in the morning, the boiler fires for a moment and the pump starts, then the green light goes off but the pump continues to circulate the water. The temperature of the water on the boilers digital display drops...
I am preparing to refinish my bathtub. The tub faucet leaks one drop/second. Obviously, I can't begin spray painting with a wet tub. What can I use to block the slow leak for the 3 days it takes for 2 coats of paint to dry?
I've got a Worcester Greenstar 38CDi Classic ErP with a keyless filling link. One of the rads has a tiny leak so every few months I have to top up the system (and bleed a rad upstairs). I should get the leak fixed but since it's so minor I haven't bothered.
My actual problem is that the system...
Hello.
I have a vented system. My boiler has been cutting out. Checked and bled all radiator. Checked the tank in the loft is full and water coming in when ball pressed down.
The retern to the boiler is very hot so expect pump is too fast, as it is set to max speed (3) so slowed to mid speed...
Hi I have slow rising of pressure in boiler not sure why but blue valve its fully open and black one closed..read on web that both should be closed is that true? Trying to attach pictures
Hi folks be glad of some help with this as its puzzling me.🤔
I have an Alpha 2 15-60-130 pump serving 12 Rads with thermo valves and Hot Water cylinder. The boiler is an Alpha CD18R
Since I had another rad installed downstairs I've noticed the heating pump has been noisier than usual ie...
I’ve got a new build that’s approx 3 years old.
A couple of weeks ago the downstairs toilet started gurgling due to the water level in the bowl being low. I plunged it and that seemed to allow the water level to rise (although still not as high as I would expect).
Recently however I’ve started...
Hi everyone, new to this forum and would greatly appreciate any advice.
We installed a walk in shower with a false wall to conceal the shower, toilet and wall hung sink pipes. There was a slow leak which led to a lot of mould growth. We opened the shower pockets and cleaned pretty much all the...
Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.