Search the forum,

removal

Indian removal was the United States government policy of forced displacement of self-governing tribes of Native Americans from their ancestral homelands in the eastern United States to lands west of the Mississippi River – specifically, to a designated Indian Territory (roughly, present-day Oklahoma). The Indian Removal Act, the key law which authorized the removal of Native tribes, was signed by Andrew Jackson in 1830. Although Jackson took a hard line on Indian removal, the law was enforced primarily during the Martin Van Buren administration. After the passage of the Indian Removal Act in 1830, approximately 60,000 members of the Cherokee, Muscogee (Creek), Seminole, Chickasaw, and Choctaw nations (including thousands of their black slaves) were forcibly removed from their ancestral homelands, with thousands dying during the Trail of Tears.Indian removal, a popular policy among white settlers, was a consequence of actions by European settlers in North America during the colonial period and then by the United States government (and its citizens) until the mid-20th century. The policy traced its origins to the administration of James Monroe, although it addressed conflicts between European and Native Americans which had occurred since the 17th century and were escalating into the early 19th century (as white settlers pushed westward in the cultural belief of manifest destiny). Historical views of Indian removal have been reevaluated since that time. Widespread contemporary acceptance of the policy, due in part to the popular embrace of the concept of manifest destiny, has given way to a more-somber perspective. Historians have described the removal of Native Americans as paternalism, ethnic cleansing, or genocide.

View More On Wikipedia.org
  1. D

    Is this pipe lagging safe to remove?

    Ideally, I want to cut these redundant pipes out. I’m pretty sure this is hair felt insulation but I’m a sparky by trade so not familiar with pipe lagging. I do know pipe lagging often contained asbestos and as the house was built in 1890 and sporadically worked on ever since… could do with some...
  2. B

    No heat after radiator removal

    Good evening all, Today I removed a bedroom radiator and capped off the ends. I started with the full works - boiler switched off, drained system, removed radiator and then filled up the system. I then bled the radiators and returned the boiler pressure back to 1.5. Turned the boiler back on...
  3. P

    Dead leg problem? Outside tap removal, but pipes are underground...

    Hi all Got a very old looking outside tap at our house which is not in use. A plumber is visiting soon to do a bathroom refit, and whilst here will remove the tap and cap it off. I asked whether this would cause a problem with a "dead leg" and he said no, but I want to check with you guys...
  4. M

    Trial removal of second CH pump

    Been renovating my house and in the process improved insulation and removed quite a few rads. I've also installed more than half downstairs floor with underfloor heating which has it's own manifold with attached pump (UPS2) as supplied by the underfloor heating supplier. Boiler is sited...
  5. G

    Victorian Tap head removal

    Does anyone have any ideas how to get to the seat washer on this tap that is leaking badly at the spout. I'm assuming the gland part unscrews from the spout but I've tried this with condserable force but with no luck. I'm assuming the spindle is secured in and does not pull out. Any guidance...
  6. T

    Soil pipe boss removal.. Help

    OK so I've started and my original plan is looking good. Is the bottom of that boss push fit? Will brute force get it off? If not how am I going to cut it out .. is there a fabulous tool that will get in there between two joists and a wall. 🤯 Really don't want to be damaging kitchen underneath...
  7. G

    URGENT Removal of baxi back boiler now i have installed a combi and no heat upstairs

    i have relocated the pipes from the old boiler and remove the hot water and heating expansion pipes i have used the hot tank pipes to fix a small rad in the old airing room removed the pump and connected the flow and return from the boiler 5 out of eight rads d/stairs work the rest nothing this...
  8. B

    Can you help determine how to remove old shower valve, cross handle, no screws?

    Hello. I have an old shower valve that needs replacing. No product name, or set screw. It's got a cross handle with a diverter above the handle. My plumber thought it was similar to an American Standard T0646002.002 (except cross handle not a bar) but the insides are not the same. This was in...
  9. Farhanhaq

    Advice on old plumbing and heating system removal

    Hello, I have a commercial unit that hasn't been used for nearly 20 years. There is an old heating system and boiler in a room that powered the whole building. The system is large with a number of pipes going through out the building. I have no idea where to start with the removal of it...
  10. B

    Plastic drain pipe screwed access plug removal

    My house (built in the 1980s) has number of solvent welded screwed access plugs to clean the drain pipes in the bathroom, kitchen etc. They are similar to the polypipe one shown below but have a lower profile cross shaped grip which makes them difficult to remove and refit. Is there a special...
  11. L

    Bath Removal

    Trying to remove a bath...thought I had done the hard part with the chisel and the surround...but it simply will not budge...its plastic/fibreglass...can I just cut along the edge with a jigsaw ?? Any issues with dust from the cutting ? Thanks.
  12. W

    BBC tap head removal

    Hi, I am trying to replace the washers in a 1960's bathroom that has BBC (Barking Brassware Company) basin and matching bath taps fitted. Having difficulty in working out how to remove the tap handles that resemble a very chunky 4 pointed design. There's a small grub screw on one of the 4 sides...
  13. P

    Mixer Tap Removal please help

    Hi Please can some advise how I remove the mixer tap above these images. This retaining bracket is fixed on well and I don’t think there will be room for it to spin around. The hot water flexi seems to have come loose from the tap as it is leaking quite heavily. Unless something has failed...
  14. R

    Heating element removal

    Hello, have an existing electric radiator and wanting to replace the heating element. Was hoping this would be a simple one but stumbling at the first hurdle as no idea how to remove the existing.. see photos.. any idea how to remove this? The electric radiator is a Java cyclope by Kalirel...
  15. GrumpyGrampa

    Hep20 removal not working

    I've bought the new Hep20 Hep Key Plus. When I use it (twisting and pulling at the same time), the pipe comes out but most times the metal insert is left in the fitting. Any help would be appreciated
  16. gingalig

    Dunsley removal and unvented conversion to sealed.

    Need to pick a couple of brains whilst exposing my chasm of limited understanding. Before I qualified, about 10 years ago we had a Dunsley neutraliser fitted, combining a Firebird oil boiler and a Hunter multifuel. Over time we've never really been happy with the set up and have a shower pump...
  17. S

    Radiator removal help

    Hi folks, I need to remove this Stelrad for decorating. Its not going back, and I've a plumber coming next week to fit the new ones. Id quite like to remove it to get behind and clean up. (Im bored and its not that important) I thought it was relatively easy to cap and remove but i can't seem...
  18. Alan55

    Awkward tap washer fitting

    Hi. This one has me foxed. How do I remove the head of this tap to change the washer? The cap unscrews and lifts only as far as the knobbly top (which is moulded to the centre post). When the cap is unscrewed I can just see the thread inside but no nut to turn - even if I had an ultra thin...
  19. T

    Twist pop up bath waste removal

    Hi there, apologies if wrong forum section. we’re trying to refurb the bath drain as the chrome plating has come off. However, there appears to be a ring with 2 slots either side locking it in place. Is there a name for this part and a tool that can remove it? Or, is there another way to change...
  20. P

    Bsxi wall heater removal

    Hi can anyone tell me how I can remove the pipe fitting from the connection. Is it the silver nut above the isolator valve I need to undo or the brass nut just above the pipe connection. Thanks
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock