Hi everyone,
The water in the apartment is not heating up hot, it’s either freezing cold or lukewarm. The red and yellow lights on the grundefos pump suggest in the manual that there’s a blockage. We’ve tried resetting the tank and the grundefos but to our dismay, we thought after doing all...
Hello,
I've previously created a thread about my Megaflo issues in the past, Baxi have agreed to replace the cylinder as an appliance change under warranty. May I ask if you you guys can have a look at my install and recommend any optimisations, prior to Baxi installing the new cylinder.
I do...
The official line is that a Megaflo needs annual servicing.
I have a Megaflo cylinder that was serviced about 2 years ago when we moved in. Only 2 house occupants. After an honest opinion on if a service is required?
I know how to recharge the airgap and have done that twice in the 2 years...
Hi guys was wondering if anyone can advise on the frequency of having to recharge a megaflo air bubble? I have had mine installed not for 6 months and noticed the turndish was dripping, so I shut the cold feed off, let the pressure off and regened the air bubble. This seems to have sorted the...
Hello, Hope you guys can help, I have a conk/clunk noise coming out the cylinder, when I draw hot water from any tap in the house - I’ve checked the pipes and I’m very sure its not water hammer, I will attached couple of recordings to the this post and what my setup looks like.
The cylinder is...
I have a loud clunking noise coming from the PRV when the cold water is shut off. It has been doing it for at least a year now but its getting annoying and I have noticed in the night (when the water pressure rises) I am getting random clunks from this valve after about 11pm at night. I am...
I have a megaflo unvented cylinder on the first floor of my property and I am trying to recharge the air gap. I have turned off the incoming cold mains valve upstream (and right next to) the pressure regulating valve and then opened the hot water taps at the lowest point in the house. The...
Hi all. I’ve got a 250i unvented HW cylinder on back order for 10 weeks and it doesn’t look like I’m getting it anytime soon. Looking for recommendations on good alternatives. I’ve a new EcoFit pure system just fitted and am keen on Vaillant storage cylinders, but my plumbers recommended...
Hi guys im looking for some advice, im a individual commercial heating engineer and i bought a megaflo eco for my place. Are the air bubbles reliable? As in worth the extra money compared to fitting an external expansion vessel. I don't have my G3 so going to pay a registered plumbing company...
Hi I'm tying / hoping to run a drain for an Unvented indirect cylinder
I need to run it now as I want to close in the building ( its in a loft conversion )
I'm having great difficulty getting someone to fit the whole system
for me , it was being done by a guy but now he can not do it as...
Hi. I have a Baxi Megaflo 170DD Unvented Direct Cylinder.
Over the last 24 hours, the water pipes leading in to it have been making noises every couple of minutes - as if there’s a heavy flow of water, then a sudden stop.
This repeats every couple of minutes.
Any idea what is causing this...
Hi
issue: No water from hot taps being fed from megaflo.
Was having HW pressure issues, obvious from no flow in attic but very low flow on ground floor, so decided to drain and recharge megaflo.
After draining megaflo from drain cock (as on ground floor),with lower tap open and odd t&p valve...
Morning
Is there a maximum distance from the megaflo that the hot water motorised valve connected to the cyl stat ?
moving tank from cupboard to attic
Cheers
Afternoon folks,
I have a mixer shower in my en suite which is closest to my Megaflo cylinder. They are back to back in the house. We have had issues with that foghorn noise from the hot water kitchen tap a few weeks ago even though it was nowhere near as loud. That got sorted when i did the...
Hi all. If you were retrofitting a Megaflo with system boiler, would you be wanting to have a direct mains water feed going into the Megaflo first and then the feed continuing into the rest of the house or doesn't it matter? At the moment, the mains water go straight into the kitchen (where the...
My 30yr old MegaFlo CL145 apparently needs a new immersion element. It has only been used on rare occasions, when the gas boiler was offline, but now blows the fuse after 20min of operation....
The engineer has just taken a look and says my installation is missing a drain point on the mains-in...
Morning.
I live in a new build house where the boiler, separate hot water tank and en suite are all in the attic. The hot water tank is a megaflo unvented indirect cylinder.
We've been here 9 years now but in the last few months the water pressure in the en suite has deteriorated quite badly...
Hi all,
Megaflo 300i in the loft. I noticed the overflow was dripping and also the tundish. 10 second google and lots of instructions how an average user (I'm very average) can recharge the air gap. Followed to the letter:
Closed mains feed to megaflo
Opened lowest hot tap. It drained pretty...
Hello , ive recently gone out on my own, i have been working in the industry 15years now /g3 qualified and i would just like to get some advice from the knowledgable people on this forum! i have done a lot of installing but haven't really got involved with the design as somebody else has done...
Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.