You are using an out of date browser. It may not display this or other websites correctly. You should upgrade or use an alternative browser.
inlet
An inlet is an indentation of a shoreline, usually long and narrow, such as a small bay or arm, that often leads to an enclosed body of salt water, such as a sound, bay, lagoon, or marsh.
Hello,
The old Baxi Potterton Promax 24HE heat only, installed when the house was built in 2003, is on its last legs.
I've decided to replace it and after some research I've bought a Viessmann Vitodens WB1B316 (part no. 7416307) 13kW heat only boiler. The downsizing of the boiler is not a...
Fitting a new burlington toilet, but not sure about what kind of attachment I need here. The pipe is 15mm and I presume I need a male-female flexihose (see picture) but these seem hard to find. Can I use a 'nipple' and if so what size would that be since I don't understand how these measurements...
Hi all. I noticed today that some stains have appeared on my downstairs hall ceiling, just beneath the en-suite - there is a large sort of brownish or rust-coloured patch just about where the shower tray is and then a much paler patch over to the right, roughly below where the toilet pan sits...
Hi, we have had a downstairs toilet and utility room built and I need to plumb in the toilet including a Durgo. The branch has a toilet, 2 sinks, a washing machine and dishwasher running into it. What airflow would I need and does it need to be on a full 110mm pipe?
We have a dedicated 110mm...
The inlet valve bottom entry to toilet cistern developed a drip that flowed under toilet and dampened grout on tiles. Initially I could not figure where leak was so fearing it was an underfloor pipe I called out the original plumber from 13 years ago. Turns out it was the inlet valve to...
OK so disclaimer – i'm a millennial who hates DIY – BUT I sincerely want to learn and acknowledge I need to get over the embarrassment of not knowing a lot.
The main thing is I don't want to be ripped off by plumbers so I need to figure this stuff out.
So... I have two push-button toilets both...
Went to a property earlier today, the vaillant ecotec has a variable flu kit installed. The outlet of the flu goes through the roof, the air inlet in inside a built in side way with a plastic roof. I at risked the boiler and want to send the relevant regulation to the client explaining what I...
Hi all and thanks in advance for any advice that you are able to give me.
I am having an issue with the inlet pipe to my toilet cistern. I have attached a photo of the setup but the water is leaking from the join between the metal nut at the top and the plastic pipe coming from the cistern...
The plug on the opposite side of the red cap with 4.5 is leaking. I have tried tightening it but unsuccessful.
My postcode is BA3 4JL, west of Radstock in Somerset. Hopefully a plumber would like the job - social distancing guaranteed during the job!
1587214286
Plumber found, please cancel...
I have a pressurised system with a Gledhill inlet control valve. There is a red cap with 4.5 Bar written on it and at the opposite side of the cap is a black, octagonal 'bolt head'. There is a drip from that about every 3 seconds. I have tried to tighten it down but it appears stuck and I...
Hi, I recently had a new kitchen fitted and it appears that the old cold water inlet valves (one pipe with 2 blue T valves connectors for old d/w and w/m) have been left in situ without being capped off.
I’m very worried that they’ll leak, especially as they don’t have a cap on them. Problem...
It says in the manufactures instructions that a 24kw ideal boiler will work ok with a gas inlet pressure of 14mb or more. With a working pressure at the meter of 19-23mb this will be far greater than the allowed 1mb drop for the pipework. They allow 1.5mb drop for the gas valve too. If...
Hi all
I’ve had an issue with the amount of water coming through two side inlet valves.
There are 3 toilets in total. All are tank fed.
1 toilet bottom entry.
2 toilets are side entry.
The tank is above and comes down through the ceiling into the toilet through a 22mm pipe.
It then t’s...
Hi all,
Apologies for horrendous terminology and lack of knowledge but I need to remove a vertical radiator which has a H shaped block as shown in the attached image.
It seems obvious on my traditional radiators, but on this one I cannot see how to shut off the water to the radiator.
Thanks...
Just fitted a new WC and all okay except I cannot get the bottom water inlet to seal. It is a Fluid master setup. It drips from between the cistern base and the plastic nut not between the nut and the thread. It came with a flat washer, have even tried 2 washers, came with a spare in case...
Hi all,
Our boiler water pressure has dropped and I need to refill to get it to work again but the valve on the water inlet pipe is very odd and I can't find a tool or key to turn it.
Does anyone recognize this and know what and where I can get a key?
Any help, much appreciated.
Rob
I'm replacing a toilet pan & the current install has a pan connected to the soil pipe with a flexi wate, but the pan exit is almost 100% lower than the soil pipe entry. Short of setting the pan on plinth, what would be the correct install?
I’m replacing the toilet and it has a 15mm threaded water inlet and I need to connect this to an isolation valve that’s already in place on the copper pipe. Thought it would be easy to find a 15mm to 15mm connecting pipe to screw into both ends but it seems not.
Any suggestions where I can...
Hi, All
I am a DIY enthusiastic kind of guy and in a bit of pickle.
I live in a rented place and have no plumbing for a dishwasher.
Need to know if I can connect inlet of a dishwasher into tap of my sink
I saw some item on eBay like below
Washing Machine Faucet Quick Brass Water Tap Hose...
Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.