Search the forum,

ideal

iDEAL is an e-commerce payment system used in the Netherlands, based on online banking. Introduced in 2005, this payment method allows customers to buy on the Internet using direct online transfers from their bank account.
iDEAL remains by far the most popular method for online payments in the Netherlands, well beyond credit card use, and was used for 54% of all Dutch online payments in 2014. The service processed 4.5 million transfers in 2006, 15 million transfers in 2007, 28 million transfers in 2008, 45.4 million in 2009, 68.8 million in 2010, 93.8 million in 2011, 117.2 million in 2012, 142.5 million in 2013, 180.2 million in 2014, 222 million in 2015, 282 million in 2016 and in 2019 655 million transactions. iDEAL is owned by the Dutch organization Currence, which also owned PIN and Chipknip. As of April 2016, the total amount of payments exceeded one billion.The participating banks in iDEAL are ABN AMRO, bunq, Friesland Bank, ING Bank, Knab, Rabobank, Revolut, Triodos Bank, Van Lanschot and De Volksbank. Together they serve the vast majority of the Dutch online banking market.

View More On Wikipedia.org
Recent contents Top users
  1. B

    Ideal Classic - is there something wrong with the flame?

    Hi, my first post. I have an Ideal Classic FF230 which has been noisy for a while but recently has gone a little quiet. It used to make a noise which seemed like the fan was going but that seems to have gone. Now the burner shows a mix of orange with the blue flame and there seems to be red...
  2. G

    Noisey ideal logic combi

    Hi , I’ve got an ideal logic making a humming noise . Has anyone got any experience of this ? Thanks in advance. Greg
  3. trickyguns

    Ideal Vulcan SX / DLX gravity fed boiler - No hot water

    HI everyone, I went to look at a prehistoric gravity fed Ideal Vulcan SX / DLX boiler with reports of no heating or hot water. This is a 4 pipe 28mm pump fed heating and gravity fed water pipes to water cylinder. I found that the heating pump had stopped spinning and found sludge behind the...
  4. F

    Ideal Isar HE30 Condensate Trap

    Hi all, Got home today and the dreaded Ideal Isar boiler had stopped working on me. Error L:F flashing on the control panel Took the front off and noticed a small trickle of water dripping around a small copper pipe on the left hand side According to a few things that I've seen online the...
    • Flook75
    • Thread
    • america condensate he30 ideal isar trap usa
    • Replies: 2
    • Forum: USA
  5. CorgiDirect

    Best Prices on top, Ideal, Vaillant, Glow Worm, Heating Spares

    We have introduced a range of top heating spares from select manufacturers , Take a look here Heating Spares - CorgiDirect - https://www.corgi-direct.com/heating-spares-17866-0000
    • CorgiDirect
    • Thread
    • america central heating system glow glow worm heating ideal prices spares top usa vaillant worm
    • Replies: 0
    • Forum: USA
  6. S

    Ideal Mini 28 Replacement Boiler

    Hello Everyone, I've just joined and am trying to help a damsel in distress - in very remote area of West Scotland. I'm hoping someone can help me here. Her 17 year old Ideal Mini 28 combi boiler has stopped working. She's had someone round to look and has been told she needs a new boiler...
    • Scott54321
    • Thread
    • america boiler ideal mini replacement replacement boiler usa
    • Replies: 4
    • Forum: USA
  7. M

    Ideal boiler displaying F1 error but pressure is as should be

    My boiler is displaying the F1 error meaning I have no hot water or heating. A quick google search tells me that this error is caused by low pressure and theres many tutorials on increasing the pressure. However, my problem is that the pressure guage is telling me the boiler is at ideal pressure...
    • MaxM150500
    • Thread
    • america boiler error ideal pressure should usa
    • Replies: 3
    • Forum: USA
  8. J

    Ideal Logic System S24IE

    This boiler was flooded through the condense drain which was connected to a gutter downpipe that was blocked at the end. The people came home to a flooded kitchen. Water came back up the condense tru the trap up the heat exchanger and out tru the fan and gas valve connection imside the casing...
  9. G

    HA fault on ideal isar 24he.

    Replaced a main heat ex today for a customer on an ideal isar, heating is ok but when running hot water it overheats and comes up with HA fault code, only happens on hot water though. Any way to shift the air from the plate heat ex? Its situated flat in these boilers instead of the usual on its...
  10. D

    I have a F1 fault code on my ideal boiler, the pressure is fine?

    Pressure is ok but increased to see if boiler would click into action but didn’t, have reduced back, needle is moving on pressure gauge, have tried reset but still nothing, any ideas before I call someone out? Thanks
  11. J

    Ideal Standard moments seat

    Having replaced the soft close seat on this suite twice,(which are not cheap), plus the soft close hinges, does anyone know of a viable alternative soft close seat that looks good on it. Many thanks. Dave
  12. soother

    Ideal logic primary heat exchanger leak sealant success?

    A mate tells me he cured a heat engine leak on this boiler (confirmed by boiler isolation & dripping condensate drain) by adding K-Seal car type sealant, and It's still ok after 5 years. Has anyone else had success curing these leaks with sealant additives?
    • soother
    • Thread
    • america exchanger heat heat exchanger ideal ideal logic leak logic primary sealant usa
    • Replies: 7
    • Forum: USA
  13. S

    URGENT Ideal logic losing water!

    Ideal Combi bolier. When I repressurise the system to 1bar it almost immediately dumps the water out the condensate pipe before even switching in on at mains. HELP!
    • Simonzo1
    • Thread
    • combi ideal ideal combi ideal logic logic losing pipe repressurise system urgent water
    • Replies: 8
    • Forum: DIY Plumbing Forum
  14. G

    ideal straight swap for the potterton suprima to run a gledhill Boilermate 2000 ?

    I have a potterton suprima 50l running a gledhill Boilermate 2000 job on at the minute. the potterton failed its CPA test with a ratio of 0.1205 and its kicking out a terrible odour. the customers opted for a replacement but I'm a lil stumped on ideal straight swaps. ideally I'd of opted for...
    • gledhillnewby
    • Thread
    • america boiler boilermate boilermate 2000 gledhill ideal potterton potterton suprima straight suprima test urgent usa
    • Replies: 5
    • Forum: USA
  15. F

    Ideal Combi hot water but noi heating

    Hi all. Daughter's boiler again thanks for help last year. New problem - hot water works fine, but when calls for heat boiler starts and runs for a few seconds then stops. No error messages. My thought is that pump is inop, so boiler starts up but then switches off when the small amount of...
    • fiddler3
    • Thread
    • america central heating system combi heating hot hot water ideal ideal combi usa water
    • Replies: 16
    • Forum: USA
  16. Y

    Ideal Isar HE35 Making Clicking and Clunking noise on Startup

    Hi, I have kept this piece of rubbish going for quite a long time and I don't like the idea of getting defeated by it! Every year there is something new to tackle and replace. I will eventually replace it for a real one! I have now got a problem that I can't work out and was wondering if some...
    • Yoda
    • Thread
    • america clicking clicking and clunking clunking he35 ideal isar making noise usa
    • Replies: 0
    • Forum: USA
  17. T

    Ideal Logic+heat 24 (not combi)

    Hi I have an Ideal Logic+heat 24 (Not Combi) it is: Alternatly flashing between: 0 (on its own) and C (on its own) when in central heating mode, it works fine on water only, any idea as to the fault? many thanks Tom
    • tommycool
    • Thread
    • america central central heating system combi fault ideal usa
    • Replies: 2
    • Forum: USA
  18. WaterWorks420

    Ideal Logic Combi ES38 No control

    Hello, I have a Logic Combi ES38 Boiler and for some reason, it's ignoring the commands from the thermostats on the wall, for example, both thermostats are set to off but yet the boiler is still on, I've tried the following: I've turned it to just water and not radiators no effect. Changed the...
  19. S

    IDEAL ICOS HE 15 L&F Troubleshooting Help Required

    Hi, I have a an IDEAL ICOS HE 15 boiler that was fitted in 2005 to a new build property and in general it's been pretty reliable over the years. However the last few weeks it started to show an L&F fault, which a reset normally clears for a week or so. However yesterday morning I woke to the L&F...
  20. T

    ideal he15 advice please

    hi all , was having a few problems with my heating/hot water when water was put on it would heat up but also heat the radiators up so after bit off searching came up with the 3way port valve so i changed for a new one as when i looked at it when the water was on it was making a buzzing noise, so...
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock