Search the forum,

he18

The Heinkel HE 18 was a sports aircraft built in Germany in the mid 1920s. It was a two-seat conventional low-wing monoplane. A development of the HE 3, it had a narrower fuselage than the HE3, having tandem seating instead of side-by-side. Also, its wings were braced by a pair of struts on each side, arranged in a V-shape with a single attachment point on each side of the upper fuselage, where the HE 3 had cantilever wings. The wings could be folded flat along the sides of the fuselage for transport or storage, and a choice of wheeled or float undercarriage was available. A roll-bar was available that could be fitted in order to protect the occupants in case of a roll-over on the ground.

View More On Wikipedia.org
Recent contents Top users
  1. C

    Thermostatic shower with an ideal HE18 Condenser Boiler

    Hi all , I am in the process of having a new bathroom installed and have an Ideal HE18 condenser boiler with a cold water tank and hot water tank in the loft. I have to turn the hot water on to be heated when I want a bath and I currently have an electric shower . With the new bathroom , I...
    • ChristopherB
    • Thread
    • america boiler condenser he18 ideal shower thermostatic usa
    • Replies: 2
    • Forum: USA
  2. U

    Hi all. CH fails to work on timed / auto. Constantly seems to cavitate.

    Ideal Icos HE18. Y plan. Ok when on constant. Set to auto and when firing up of an evening, banging and clattering. Any suggestions pls?
    • Ukstealthbomber
    • Thread
    • auto constantly he18 icos ideal seems timed urgent winter work
    • Replies: 3
    • Forum: Canada
  3. K

    Noisy boiler (Rubbish Ferroli HE18)

    I have probably one of the worst boilers you could have (not my fault, blame the home developer!) It's a Ferroli Optimax HE18s. We are getting a really loud vibrating noise when the hot water comes on. But if I switch the boiler off then on again and stops straight away and carries on like...
  4. C

    Icos he18 l and f code

    Hi all. Hope you can help. Been to look at an ideal icos he 18 l & f code. Done everything from the flow chart and changed the flame detection probe. Contacted ideal and they're advice was to boil the kettle a few times and flush the heat exchanger to clear the aluminium oxide build up. Ive...
  5. B

    Boiler stays in 'C' status even when it should be off - icos he18

    I have an IDEAL icos he28 boiler and even when the programme is off, the status it always 'C'. When it's off the LED flashes and then when it fires up the LED stays on. I know from the manual that when the LED is on the boiler is working and when it's flashing the required temp has been achieved...
  6. D

    Icos HE18 - Hot water far too hot

    I have a puzzling problem with my heating system. System comprises of Ideal icos HE18 boiler, Grundfos ALPHA2 Pump, Drayton MA1 Actuator, Drayton HT53 Tank Thermostat. To cut a long story as short as possible: I have a system that is generating Hot water that is far hotter than it should be...
  7. B

    ideal icos he18

    pcb dead so fit new pcb still dead check gas valve 200v 22mbar inlet -3mbar outlet check venture clean burner straighten spark electrodes fit new sensing electrode check continuity of detection lead clean condensate trap it will work very occasionally but no where near enough to pack tools away...
  8. B

    Ideal Icos HE18 Dead

    HI, 2 days ago I've noticed that my central heating doesn't work however the hot water was OK. The engineer told that its 3 way value fault. He switched lever on the valve and radiators were warm again (he said that he will get spare parts and change the valve). Everything seemed to be OK but...
  9. L

    icos ideal HE18 boiler only works for a short time - no fault code

    Hi I have had reason to drain my central heating system and take off 2 radiators. After refilling and turning the system back on,everything seemed ok. After switching the boiler on, it went to standby mode (O) on the control unit. Then after switching on the CH and hot water on the controller in...
    • lezmclair
    • Thread
    • after boiler code control fault he18 icos ideal oil short time water works
    • Replies: 8
    • Forum: Plumbing Jobs | The Job-board
  10. H

    Potterton HE18 BOILER

    Hi Guys I have problem with my boiler it was running normally until Thursday night when I noticed the rads were hot even though the thermostat was on low. The boiler carried on till the pressure went in to the red it then cut out. The boiler will run normally with just the water on but as soon...
  11. S

    Ideal Classic HE18 Central Heating Problem

    Hi, I have an Ideal Classic HE18 boiler that was installed in October 2005. Generally we have not had any issues with it but have noticed recently that especially when CH is called for that the boiler will ignite for approx 1-2 mins and then switch off again and then repeat this each time. The...
    • shrimpd
    • Thread
    • boiler central central heating system classic could he18 ideal problem water
    • Replies: 6
    • Forum: Plumbing Jobs | The Job-board
  12. B

    Ideal HE18 Boiler issues

    Please advise. We have an Ideal HE18 boiler which is only 3years old. The issue we have is the boiler is showing the letter 'C' but is failing to light up the boiler so no flashing then permanent blue light. I think it's an issue with the hot water side of things as twice over the last 3 days we...
    • Benjamin's
    • Thread
    • boiler central heating system could engineer he18 ideal issue issues oil
    • Replies: 13
    • Forum: Plumbing Jobs | The Job-board
  13. L

    Servicing of Ferroli Ecotop Pressurised Solar Water Heating System & Ideal ICOS HE18

    Hi All I’m hoping that someone knowledgeable can help me with the following. We have a 1 year old new home that was fitted with the following heating system: • Ferroli Ecotop Pressurised Solar Water Heating Systemo Aquacyl Twin Coil Cylinder o Twin Line Pumping Station • Ideal...
    • LRS
    • Thread
    • ferroli he18 heating heating system icos ideal pressurised service servicing solar system water
    • Replies: 4
    • Forum: Plumbing Jobs | The Job-board
  14. T

    Ideal ICOS HE18 boiler - hot water but no Central Heating?

    Help! I have an Ideal Icos HE18 boiler, the status screen shows C which means it is operating normally with no fault but we have no central heating. Hot water is still working fine. We had a very short power outage yesterday so I don't know if that has anything to do with it but I've checked...
    • The Applebys
    • Thread
    • boiler central central heating system he18 hot hot water icos ideal no central heating oil water
    • Replies: 1
    • Forum: Plumbing Jobs | The Job-board
  15. M

    an ideal icos he18 story

    well.....i went to an icos on yesterday which had blown the fuse on the pcb and it did it twice more on me so disconnected all the wiring to bar the the 2 x four pin harnesess's as instructed by ideal tec just to check to see if pcb was at fault...switched it back on again and boom!! so off i...
  16. S

    Ideal Icos HE18 no display?

    hi my Ideal Icos boiler has recently stoped working, there is no lights on the display and there is 240v supply to it and no fuses have blown, ANY IDEAS?? I'm thinking the worst and i think the pcb has gone, but what would cause this to go?:banghead:​
  17. R

    Ideal icos he18

    What is the significance of fladshing letters H and E ? Thank you
  18. N

    Ideal Icos HE18

    Hi All, Seem to have a bit of a problem with my central heating system. All was working fine this morning. Now I only seem to have heating upstairs. Hot water is fine. Read through manual, and a lot of the other posts on here, oh deep joy! Think I have just found the catch to Warm Front. I...
  19. T

    icos he18 boiler

    my grandad had this boiler fitted just before we bought his house, he never knew how it all worked and neither do we. Today it has been on 0 status all day so we have had no heating. It seems to just go onto 0 for no reason when none of the settings on thermostat have been changed and heating...
  20. R

    Ideal Icos Boiler HE18 Problem with bubbling

    Checked and drained down condensate trap line is not frozen and trap is clear, heats domestic and central heating water ok on low fire set point 4 but once burner is increased bubbling and banging starts inside the boiler. Can overcome the problem by opening the bypass around the pump but lose...
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock