Hi chaps, hope you can help I have a Glow worm Ultracom 38cxi, HW is fine but CH is not working I turned it on last week and all went well but I struggled to turn it off so I just shut down everything, it appeared to be back to normal, all lights on, all controls OK, water heats ok, today I...
I am a new poster to this forum - not a heating professional, but a householder looking for advice. please.
I have a Glow worm 18hxi boiler with Magnatech installed in 2006 by a local engineer who has serviced it regularly and comprehensively every year - very competent, has done a lot of work...
Hi folks a letting agency boiler I've been asked to diagnose and repair the first visit the fans on but no sparking first thought was aps and the orange light on the pcb was also telling me so it's the pcb with the two fuse. So new aps fitted now I have the orange light to say aps proved and...
Customer rang. Told me she had someone out, they have changed the flat plate heat exchanger. Still same problem with water runs hot for a few minutes, then runs cool. Boiler is still running. Then they have told her its because she needs a new pump and quotes her for one. Then they sent another...
Hi there, we have a glow worn 24ci boiler which won't kick in, keeps flashing 0.4 with a red light above. Have tried to Google it to see how to re-pressurise but nothing has helped. Does anyone have any suggestions please?
Got a Glow worm 18 flexicom with f22 fault.
I've replaced both flow & return thermistors, bleed all rads of air, removed the pump and cleaned it, it all seems fine and pump is strong, checked wiring continuity and that's all good. Boiler is only 6 years old and Glow worm have said it sounds like...
hi guys, replaced a combi swap a few months ago and customer has contacted me, saying sometimes when they open kitchen cold tap the boiler makes a noise but doesn't fire up?
I connected hot and cold correct way if your asking lol.
The mains pressure is very high could this be causing problems...
went out to a customer and found the pub burnt out. It’s an old ultimate 30ff. Found the replacement part number via glow worm archive and contacted Wolseley to get a price.
There does however seem to be a discrepancy. Glow worms part number is for a two fuse pcb, wolsely don’t list the...
Hi, I came in tonight and turned the central heating up. Nothing happened. It was working fine this morning. There is no pilot light and the igniter is not firing. Power is getting to the controls, as I can here a click as I turn the power on, after turning it off from the switch. I am going to...
Hello all, new member, first post....
After some advice on a Glow Worm Flexicom 30hx boiler before I throw more money at it.
It is having troubles lighting up when the temperature is below about 5°c. It tries to start as normal, fan runs and you hear a woompf as the gas ignites but it then...
Afternoon chaps, I'm at a lose.
I have just come away from a job wlempty pockets as couldn't fix the problem.
Scenario.
Glow worm 30ci combi won't fire. It sparks, fires on low flame but goes out after 5-10 seconds and then goes to F1. With all cases off right back to burner, it stays on. So...
Hi.
I'm replacing a glow-worm space saver next week. Asked to do either a Worcester Ri or Logic Heat with rear flue.
Makes no difference price wise other than get a filter included with the logic.
I've quite a few RI's so was leaning towards the ideal for a change more than anything...
Hi, over the last couple of days I’ve noticed that there's water dripping from the corner of the boiler. This only happens when the boiler is in use. Up to now the boiler is functioning and heating water and central heating. I would just like to be advised whether this is going to be a major...
Hi There
I hope you can help or point me in the right direction.
I have a Glow Worm 38CXI boiler. The Central Heating is working perfectly however a few weeks ago we started to experience a problem with the hot water. When running the shower or putting a big demand on the hot water tap the...
Please could anyone advice. I have a 36 y.o. Glow Worm Space Saver 38. I have had it for the last 6 years when bought my current house. I serviced it for the first two years but then stopped servicing in fear that it could be condemned just for being old an inefficient or no spare parts. I did...
Hi guys, I've just wasted so much time trying to figure out how do I achieve low and high firing from this boiler..
I've read the manual many times but still don't make sense.
I did a replacement boiler change which should of taken half the day not 12 hours! Due to not managing to commission the...
Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.