Hi
I want to set multiple HR92 on a single zone on my Evohome system but the documation leaves a lot to be desired so I would appreciate some help.
This is especially true as the information I have found relating to multiroom says that the Heating type should be set to "zone valve" rather than...
Hi, I like the idea of using smart TRV's so was originally looking at Hive, but I would really prefer to have local control rather than an app that requires internet access, and I need something simple that the wife can use. I started looking at Evohome as I like the look of the control panel...
Hi!
I can't seem to get my Evohome heating working as expected and it's starting to become a bit of an issue. I'm sure it's going to be down to something I've misconfigured. Any help much appreciated!
Initially, I had a simple setup: I replaced the house thermostat with the relay box and used...
I've just moved into a house for the first time where I don't just have a single heating zone. This house has a central timer unit and 4 room thermostats that control 4 Honeywell V4043H1056 valves beside an currently unidentified Johnson Starley combi boiler (although there is also a hot water...
central heating system
change
evohome
forum
heating
heating system
instead
multizone
plumbing
radiator
radiator valves
smart
system
thermostatic
trv
valves
zone
Hi, I’m looking for advice about our Honeywell Evohome system. It has never been quite right & looking at info online I think the BDR91s have been installed too close together. At the moment we have a problem with the hot water connection - on the base unit it is just showing an egg timer rather...
Hi, I’m looking for advice about our Honeywell Evohome system. It has never been quite right & looking at info online I think the BDR91s have been installed too close together. At the moment we have a problem with the hot water connection - on the base unit it is just showing an egg timer rather...
Hello
I've now had my Intergas Xclusive 24 installed and a very fine job the engineer made of it, very good, neat pipe work
Evohome/Evotouch controller with a Wireless OpenTherm Bridge (R8810A) providing boiler schedule control
Q - during setting up the daily/weekly schedule it...
After a busy year I’ve finally got some time to try and improve the controls of our heating at home.
I’ve fitted a few Nest systems and think they are quite good for smaller installs.
I’ve been looking at the Evohome equipment as the smart TRVs seem like a really good idea.
Currently the...
Hi everyone
Newcomer here and freely admit to not knowing much about central heating or even plumbing in general tbh! I've got an old (20+ years) combi at the moment that is on its last legs (hot water is intermittent plus various faults over last 18 months). Consequently I'm looking to replace...
Hi I am trying to fit the evohome system TRV to this existing TRV but I am struggling to find the manufacturer of the existing TRV to see if they make an adapter.
Good afternoon all,
I'd just like to preface the following post by saying that I'm fully aware that any work completed on an unvented cylinder requires a G3 ticket, and I don't plan to make any modifications to the hardware or the wiring of the cylinder...
My heating consists of a Greenstar 24...
Evening all
I have been researching the hell out of this, following my last project. Currently ripping half the kitchen out to remove a wall and make our downstairs open plan - If you wouldn't mind me running my plans by you to hopefully pick any obvious holes in.
Current floor is standard T&G...
Our flat uses a communal CHP system, with a Gledhill Boilermate 2000 ( https://www.gledhill-boilermate.com/wp-content/uploads/2015/12/BoilerMate-2000-Manual.pdf ) in our flat (i.e. we don't have direct access to a gas boiler).
We're looking to set up a Honeywell Evohome system consisting of a...
Hi ive bought a Honeywell evohome connected ATP921R3100 and need advice on connecting.
My boiler is a Worcester Bosch 18i system boiler
A honeywell t6360b dial thermostat
A myson 2mep 2c programmer/timer
Its a 3 story 13 year old house
Myson timer programmer is in the kitchen with the fused...
Hey all. Are these suitable for all boilers brands or certain 1s. The Home owner has this already before a boiler has been brought. Was looking at an ideal logic or potterton combi's but he was under the impression that it only worked under certain brands. Haven't come across any of these yet...
I'm thinking about installing a Honeywell evohome system in my own house. It looks good on paper but I'm still in two minds as it's a lot to spend. Has anyone out there got experience of fitting or operating it?
So 3 times now i have had this issue with my boiler turning the burner off because it senses an error on the flow/return temp sensor.
Had ideal round to check it out, no faults found they changed the sensor anyway and left me a spare then monitored the system for a while and noted that...
Hoping someone can help. Have tried all the listed suppliers on the Honeywell website and had no responses.
I have most of the system, I just need the Hot Water Kit and the certified install.
My house is only 4 years old with good wifi coverage so it should be a fairly easy install.
Please...
I have an existing heating system and am looking for a heating engineer to upgrade my system to use Honey Evohome controls.
I have 4 radiators/towel rails that do not have TRVs and these need to be replaced.
There are 13 radiators in all (including those mentioned). There is an un-vented hot...
Hi,
Wonder if someone can help, been trying to get an answer from Honeywell but can’t seem to get through with email or phonecalls :)
I’m replumbing my house (engineer, not a plumber) and am looking to do the below using EvoHome, but not sure if it works as I expect.
Setup:
S-Plan...
Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.