Search the forum,

discharge

A military discharge is given when a member of the armed forces is released from their obligation to serve. Each country's military has different types of discharge. They are generally based on whether the persons completed their training and then fully and satisfactorily completed their term of service. Other types of discharge are based on factors such as the quality of their service, whether their service had to be ended prematurely due to humanitarian or medical reasons, whether they had been found to have drug or alcohol dependency issues and whether they were complying with treatment and counseling, and whether they had demerits or punishments for infractions or were convicted of any crimes. These factors affect whether they will be asked or allowed to re-enlist and whether they qualify for benefits after their discharge.

View More On Wikipedia.org
  1. P

    Megaflow discharge problem

    Hi Can anyone help. I went to look at a Megaflow, last Saturday ( I have my unvented card) the client was saying that in the evenings, every two or three days the megaflow discharges hot water out of the discharge pipe. It is a 210litre direct megaflow unvented cylinder There was no leak...
  2. J

    Discharge into header tank

    Ok so was at a job yesterday, customer said boiling water had been discharging from his header tank for the past 4 months. I took a look, got everything up and running, stayed for a good half hour everything seemed to be working perfectly and just as I was about to leave boom the pump started to...
  3. B

    Flimsy Pressure Relief Valve

    I have a combi boiler: Chaffoteaux Minima MX2. A few days ago water started leaking from the PRV. It was leaking from the seat and from the side where the discharge pipe is connected via a 15mm tap connector. The tap connector is not 90 degrees and looks like its had the end hacked off. It has...
  4. U

    Are you allowed to run a discharge pipe from a cylinder into a soil pipe?

    as above, cheers
  5. L

    Unvented -tesy

    Been called out to look at a couple of these today as LA Bldg Control have said they wont sign off until the discharge from it incorporates an HEP V O Valve. Can understand what there saying even though its 15mm discharge has been run into a vertical piece of 32mm waste pipe, siliconed at the...
  6. F

    Pressure relief discharge pipe - inadequate piping

    Just been to do a load of gas safety checks on a block of flats, asides from having to I.D and disconnect a fire I came across another issue. I noticed that the pipe on the pressure relief valves, from the boilers I looked at were not quite right. Instead of exiting the property with two...
  7. P

    Cold water discharge from vent on f&e!

    Hi guys, I have a little problem at a customers property that really I just want confirmation that I am going down the right route(don't want to keep having to go back & cost her an arm & a leg lol). I have attached a picture of the pipe work set up to help illustrate my point. Basically...
  8. F

    Purple/red discharge from showers

    Brothers recently had new house built and he's complaining about coloured discharge from mixer showers. First thought was flux but no discharge from any taps or toilets just showers. 95% of house is plastic pipe except first couple of meters in garage after stop tap. Any ideas ?
  9. P

    Vaillant Ecotec Problem - Air in system and water discharge from condensate pipe

    I have a Vaillant Ecotec 415 Plus system boiler installed a few years ago. Originally it was an open vented system, but I have recently done a renovation and made the central heating a sealed pressurised system with an external expansion vessel replacing the expansion tank. Ever since the...
  10. P

    prv discharge pipe

    been to quote a job today and its going to be a right mere to run the prv pipe to outside can you discharge it internally into a soil stack if you have a tundish ?
  11. A

    unvented discharge

    What would you guys do for a d2 discharge under floor (visible in copper) that was in 28mm hep with pushfit bends fitted, then externally in 28mm coppper. would it be NCS AR ID ? regards Al
  12. S

    saniplus discharge pipe?

    Hello guys, looking for wisdom and possibly some tips, i am fitting a saniplus soon and i know that the discharge pipe diameter size is 22mm, now does this have to be copper or can it be overflow pipe? i know copper will advantageous because of the joint free bends but i am thinking that copper...
  13. G

    Saniflo discharge pipe question

    First off, I'm new here. But not new to forums as a medium for communicating etc.... So Hi :D I have read the documents and FAQ at Saniflo but can't find any 'why' to the given directions, that seem to imply that if you go Vertically with the waste, you must do that first. I have a diagram of...
  14. K

    T&p relief valve discharge

    Right guys help would be appreciated, called out to a indirect unvented cylinder today, customer complaining on no hot water. Firstly noticed water discharge through tundish, water was hot but not boiling. Stat was set at 60 degrees. I've switched off hot water circuit at programmer then I...
  15. W

    expansion valve discharge

    I have fitted an unvented solar cylinder and the posistion of the cold supply pipework is low level...ideal to connect straight into cylinder inlet. however this would obviously mean that i will not be able to tee the expansion discharge into the D1 above the tundish. Is it possible to fit a...
  16. V

    what constitutese piping to discharge to a safe outlet on a vessel less than 15 lr?

    I have a combi boiler that has a vessel of 10 litres, I currently discharge into a 25 litre drum. I have been told that this is incorrect and that it should be to outside. Building Regulations 2000 Part G Par 3.9 talks about discharge pipes. "The discharge pipe should terminate in a safe...
  17. J

    OSO Unvented Indirect Hot Water System

    The pressure / over heat relief valve is letting by which is creating a steady trickle past the tun dish and through to an external vent. The Pt. Number referred to in the manual is 550803. However, I cannot find any reference to this on a search. The nearest I can find if 550853. My question is...
  18. S

    Boiler Prv discharge what is this classed as ?

    allright everyone Happy new year. just a quick question went to do a landload cerf today, New boiler fitted a year ago. The landloard could not get hold of the boy that fitted it. so started my checks,randomly checked the paperwork from last year no gas safe number no address just a...
  19. K

    PRV discharge pipework

    Hi, Im fitting a 28I junior tomorrow, my problem is it could be difficult to run the discharge pipework from the PRV to outside i was wondering if it is ok to run it into internall drainage. any advice will be apprechiated
  20. C

    worcester greenstar 24i junior sticky green discharge

    Hi I have a 2 year old worcester greenstar 24i junior boiler which is leaking a sticky green mess from the rear and then onto the pipes. it drips a little but not always. Worcester want to charge me £250 for a call out ...... Thanks in advance for any suggestions or help Mike
Creating content since 2001. Untold Media.

OFFICIAL SPONSORS

OFFICIAL SPONSORS

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock