Search the forum,

Discuss Crazy high mains pressure in the Plumbing Forum | Plumbing Advice area at PlumbersForums.net

Messages
1
Hi to all in the forum!

I have a 6 bar pressure relief valve attached to an under sink heater and it was always dribbling a bit. Today, I finally bought a new pressure gauge and was astounded to measure the pressure at 7 bar!

I usually find most mains to be between 2-3 bar and so it seems ridiculous for it to be so high. The job is in the middle of Bath in Somerset.

What's the highest that anyone has seen?
 
What's the highest that anyone has seen?
More than 10 bar is not uncommon in the UK, I've known ca 15 bar in one place. There is no specified maximum and supply companies do mess around with the pressure sometimes, although they rarely raise it. Increased pressure is worth reporting to the supply company if you want it reduced. There is a minimum spec but it's less than 1 bar (0.7 bar IIRC).

You need a G3 qualified plumber to install a pressure reduction valve to take the pressure down to 3bar and review the safety of your system, which seems a bit dodgy going by your description. Post a couple of pictures if you want more specific comments.
 
If the incoming supply is more than 4 bar then the unvented heater should have the appropriate kit fitted . Kop
 

Attachments

  • Screenshot_20210429-191621~2.png
    Screenshot_20210429-191621~2.png
    378.4 KB · Views: 5

Reply to Crazy high mains pressure in the Plumbing Forum | Plumbing Advice area at PlumbersForums.net

Creating content since 2001. Untold Media.

OFFICIAL SPONSORS

OFFICIAL SPONSORS

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock