• Welcome to PlumbersForums.net - The international free plumbing advice forum. Professional plumbers sharing advice with fellow plumbers and DIY alike. Register for free today! - Checkout the Plumbing Advice forum and then our Plumbing Videos area which still needs populating.

Thread Log

SMB
Hi, I need to remove a radiator fed by 10mm plastic barrier pipe, in a pressurised central heating system. I can get under the floor to the pipes. Is it OK to freeze the pipe so that it can be capped, so that I don’t have to drain down? Thanks. RB
Replies
3
Views
235
SMB
SMB
sorry if this has been asked before, searched but could not find the answer. Not too good on computers! I need to replace the large rubber washer in the ball valve. Which way does it go round into the fitting where it buts up to the white flow cone. Cheers.
Replies
3
Views
1K
SMB
SMB
Hi, Where the valves screw into the aluminium rads has started to leak (all be it not that much). The system is a ordinary pressurised sealed system. The leak is hardly enough to drop the pressure. The system has been fine for 4yr+, I guess that the rubber gasket has started to fail. I have...
Replies
5
Views
892
SMB
SMB
  • Locked
Hi, I am at present doing a project (not plumbing). I need to connect 15mm copper fitting to either 50 or 40mm plastic pipe. Does anyone know of a solvent adapter available, as I can't find one. Many thanks. SMB
Replies
3
Views
645
SMB
Top