Users can remove all display ads (not sponsors) for a small fee. Click for info (must be logged in)

Recent content by josh 10

  1. J

    Concealed sistern not fully flushing rimless pan

    Hi sorry not to have responded sooner. Other problems came up which took precedence. I will get round to checking the level of water in the cistern as soon as I can and report back. Thanks to all who have advised. josh
  2. J

    Concealed sistern not fully flushing rimless pan

    Hi Thanks for your response. The whole thing was new a few months ago. Water is flushing through OK just not enough volume to reach properly to the from to the pan. I was wondering if the actual valve comes in different sizes. A bigger one to let the water through faster? It does seem to come...
  3. J

    Concealed sistern not fully flushing rimless pan

    Hi I have two loos one with a concealed sistern and a rimless pan The other against a wall close coupled also with a rimless pan. This unit has a really strong flush which meets at the front of the pan and thoroughly cleans. The first unit with the concealed sistern has a much weaker flush and...
    • josh 10
    • Thread
    • america concealed flushing fully pan rimless usa
    • Replies: 5
    • Forum: USA
  4. J

    Extending heating system

    Yes that's the one I use to bring the system up to pressure. If it's of use I run the system at 1bar. I also have a grey one. Not sure what it does. I really should investigate.
  5. J

    Extending heating system

    Boiler Gloworm 30HXi. Radiators 13+3 towel rads. Hot water tank. Santon Premier unvented indirect cylinder. 210ltrs. Hope this helps. Look forward to hearing from you. josh
  6. J

    Extending heating system

    Thanks Chris. I think design was what I meant to say, not regs. It's the regs that control the design. josh.
  7. J

    Extending heating system

    Hi Chris. Thanks for the super quick response. From what you say, dependant on certain parameters we should be able to add a couple of radiators with out too much of a problem. I take it '20deg C delta T' are the regs the boiler should have been built to. This gives me something to discuss with...
  8. J

    Extending heating system

    Hi. My first post and I am not a professionel just a retired engineer and a keen diyer so please bear with me if I get some terminology wrong. We are in the process of adding an extension to our house. Two floors. I am going to need to extend the heating system and am wondering what I should be...
  9. J

    Shower mixer identification

    Thank you kris and rpm. I actually would like to reuse the mixer. We have good water pressure and it works well without the complications of a thermostatic mixer. On the centre of the temperature control is a capital T made up of a double line of dots if that is any help. rpm. How do I find the...
  10. J

    Shower mixer identification

    Hi my first time of posting. Can anyone help please. I have a shower mixer that is approx 10 yrs old. Photo attached. I want to redo the bathroom but I cannot see how to take it off. I feel if I had a manufacturers name I might be able to find the information on the internet. Can anyone help...
  11. J

    Pump not shutting down

    Hi Thanks for posting. The pump does not stop when when timer set to off on both HW and CH. Pump only stops when I switch off at the wall switch for the system. josh.
  12. J

    Pump not shutting down

    Hi. I have a strange problem. I cannot stop the circulating pump from running on my heating and hot water system. I have had problems in the past with a Danfoss motorised valve not shutting completely on the hot water side and causing a continuous running of the system. Removing the motor and...

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock