Search the forum,

Recent content by Chester

  1. C

    SANIFLO discharge query

    Yeah it's not right, it'll block again eventually because it's let out.. can guarantee the kitchen sink is what's properly blocked it before mind you, always the fat 😭
  2. C

    SANIFLO discharge query

    Just want to add I branched in on a Y so slightly better flow not a tee
  3. C

    SANIFLO discharge query

    Thanks for the reply, against this advice I ended up teeing into the 2inch 🤪 as time was of the essence, I called Saniflo Technical and whilst he said the ideal scenario is on its own run you can as long as you (me) thinks the run can handle full flow, it was OK, kitchen sink doesn't gurgle...
  4. C

    SANIFLO discharge query

    Hi guys question about saniflos 💩 I'm working at a property that the entire place was fed off a sani, that's packed up, blocked the line entirely and they've urgently had to get me to replace and make some changes, initially I was going to install a sanivite for the kitchen sink separately...
  5. C

    Gully patio'd over in use

    Update, pipe on right is compromised, failed pressure test, inspection with camera can see a joint directly where the tiles begin to sound 'hollow', upsized left pipe and temp fix running everything through the 1¼ under basin as it's under a tiled floor so not an easy fix.
  6. C

    Gully patio'd over in use

    Hi guys not sure anyone has encountered this before but I have a job where the inside wall has been getting a little damp, there was a step up to the door that I think wasn't helping due to dpc but that was removed to take a closer look and it revealed 2 waste water pipes going into the patio...
  7. IMG-20230921-WA0008.jpg

    IMG-20230921-WA0008.jpg

  8. C

    Flats bathrooms fed by tank?

    Hi guys I did a job today in a block of flats, fairly old place, plumbing was all a bit ropey in this particular flat. The job was to change an electric shower over, I changed it, didn't work.. noticed the water pressure was a bit pants.. I could stop it with my finger on the basin.. thought...
  9. C

    Programmer fault/wireless stat wiring?

    Thanks, the installer had linked a permanent live from the L and N side of the stat to A I believe it was, I don't think it's necessary in this scenario.. however in the manual it says do this on a 2 port but absolutely no mention of programmer's etc. The bit I don't understand in this situation...
  10. C

    Programmer fault/wireless stat wiring?

    I have accessed the wiring centre, there is 240v coming up from the programmer/thermostat in fault state. This might be a silly question but how does an RF stat with a permanent live supply to the receiver not override the programmer on timed? I understand that the receiver is hard wired in and...
  11. C

    Programmer fault/wireless stat wiring?

    They say they're not sure but I suspect it hasn't. Yes i have all kit
  12. C

    Programmer fault/wireless stat wiring?

    Yes it was tested when the programmer was in an off time period, yet in the loft where the wiring centre is unfortunately, the pump was on (wired into the switch lives in wiring centre) and the 2 port was open still..but I will double check again before I make any alterations. Let's just assume...
  13. C

    Programmer fault/wireless stat wiring?

    It remains live regardless of the programmer timings, until they turn the stat down it doesn't stop they say. Although when I was there I set the timings and waited until it clicked off and it did in fact switch off when it was supposed to so I'm led to think the programmer is at fault. I guess...
  14. C

    Programmer fault/wireless stat wiring?

    But the Zone valve brown signalled from the stat is live?
  15. C

    Programmer fault/wireless stat wiring?

    This is what I initially thought it was but it seems to move fine manually, the brown is definitely being signalled to hold it open
Creating content since 2001. Untold Media.

OFFICIAL SPONSORS

OFFICIAL SPONSORS

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock