Hard to tell from the photos but the cast end looks a fair bit lower than what's been attached to it - if you got rid of that length of black plastic pipe and the rubber adaptor and see if the flexi will go straight into the cast (assuming it would fit - they sometimes do with the fins cut off).
Thanks for the replies. They were trying to get away from the "tap" type due to arthritis etc. He's been measuring tank height and head is indeed 0.2 bar. He has no paitence and since me posting he has ordered another tap - a Premier Eon DTY306 which allegedly works at 0.1 bar. I'm not convinced...
Hi, my parents recently replaced their old 15mm gravity fed kitchen mixer tap (the old fashioned sort with separate hot and cold taps, rubber washers etc). They fitted a single lever mixer (I think it was a crosswater) that claimed to be suitable for low pressure.
Anyway, it's no good - reading...
Thanks, the idea of just a timer controlling the bedrooms sounds low tech enough for me (I'm not that keen on all the wireless stuff to be honest). Could I use a 2port valve (which I have) without the switching circuit and control this from channel 2 of the programmer? I know the bedrooms could...
Hi, it will be, the whole 40 year old system is being replaced/repiped in stages in conjunction with renovating and extending the house. The upstairs rooms will be fed by individual 15mm branches off a 22mm manifold in the cupboard where the valves, cylinder etc will live so it's just an extra 2...
Hi, I want to create a heating zone for my 4 bedrooms upstairs. I'm a bit unsure about where to put the second stat - other than the bedrooms there's just a landing at the top of the open plan stairwell - if I put it there it will be affected by the heat rising from below. Does this matter and...
Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.