Search the forum,

Discuss What to do with a rodding point. in the UK Plumbing Forum | Plumbing Advice area at PlumbersForums.net

Messages
3
I started digging up my garden to lay some new patio slabs and found this (rodding point, I believe) covered with grass. The new slabs will be an inch or so above the level of the old ones. What are my options for dealing with this?
IMG_20220811_101350.jpg
IMG_20220811_101503.jpg
 
It seems to be in an odd location with respect to the house, the flow would appear to be towards or under the house, is that an extension?
Also have you had the cover off to see if it is connected, it may just be an abandoned piece of pipe?

I really needs to be accessible, but looks like a nice new cove would be appropriate with new slabs.
Is the new level still going to be below the level of the house damproof course?

Looking at the angle of the top cover it appears to have been pushed down into the ground.
If you excavate around the pipe you may be able to bring it up to the new level then cut the slabs or whatever around it.
 
It seems to be in an odd location with respect to the house, the flow would appear to be towards or under the house, is that an extension?
Also have you had the cover off to see if it is connected, it may just be an abandoned piece of pipe?

I really needs to be accessible, but looks like a nice new cove would be appropriate with new slabs.
Is the new level still going to be below the level of the house damproof course?

Looking at the angle of the top cover it appears to have been pushed down into the ground.
If you excavate around the pipe you may be able to bring it up to the new level then cut the slabs or whatever around it.
It is an extension, replacing a conservatory which was there when we bought the house but yes, the pipe does dive under the house
 

Reply to What to do with a rodding point. in the UK Plumbing Forum | Plumbing Advice area at PlumbersForums.net

Similar plumbing topics

I want to reconnect some outbuildings to an existing water supply. The supply pipe is old 22mm MDPE and buried for a fair distance so not going to dig it up and replace it 😬. Question is can I use normal 22mm plumbing push-fit connectors to make the connection as finding 22mm MDPE fittings...
Replies
1
Views
190
Hi all Noticed bad smell in my drain out side put my hand down and it unclogged it for now however I checked my sewer drain and after flushing my toilet a good few times nothing is going to the sewer so don't know is there a blockage or what way it works many thanks and advice would be grateful
Replies
3
Views
354
Hi, I have an old steel water mains pipe (approx 45mm) that I need to connect to a new pehd water mains (25mm). I can't get at it to create a new thread so what's the best way of connecting the two? Cheers, Peter
Replies
2
Views
146
The fittings below are for a mixer bar attached to a self contained shower. i.e not a wall. The attaching screws have snapped. I could get two new brackets, dismantle that existing one and start again or I could try and re attach via those screws, removing the broken ones from the plate and wall...
Replies
0
Views
105
Hi guys. I'm trying to identify a toilet model before ordering a seat for a customer. I went to what used to be a Roca stockist (they no longer are) and one of the guys there reckoned it might be "The Gap". I went to the new stockist and the guy there disagreed it was "The Gap" and that he'd...
Replies
2
Views
111
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock