Search the forum,

Discuss Die Size For Pipe Threading in the Plumbing Forum | Plumbing Advice area at PlumbersForums.net

Messages
4
Hi. I'm Fred. I'm putting in a new electric service, 100 A/240 V. I need to manually thread a 1 1/4" pipe Nominal Pipe Size (NPS). I'm not sure if it is tapered or not tapered. My question is: what size die do I need to threat the pipe? The outer diameter (OD) of this pipe is 1.9". Is that the die size. Thank you very much for any help.
 
Does the steel pipe have a very thick wall as normally an od of around 1.9 is 11/2 tube

11/4 should measure around 11/2 od
 
1. If you are based in the USA then pie and dies sizes may well be different from the UK. The thread will probably be National Pipe Thread (NPT).
2. This is a plumbing web site, but it sounds as if you are doing an electrical installation. Threads may differ between steel pipe and what we call conduit (electrical "piping").
3. You should be able to find the information you need on the internet, usually from piping suppliers or tap / die manufacturers.
 
1. If you are based in the USA then pie and dies sizes may well be different from the UK. The thread will probably be National Pipe Thread (NPT).
2. This is a plumbing web site, but it sounds as if you are doing an electrical installation. Threads may differ between steel pipe and what we call conduit (electrical "piping").
3. You should be able to find the information you need on the internet, usually from piping suppliers or tap / die manufacturers.
Thank you for your help. This is proving a bit more difficult that I thought.
[automerge]1601667640[/automerge]
Does the steel pipe have a very thick wall as normally an od of around 1.9 is 11/2 tube

11/4 should measure around 11/2 od
No. I am in the US. The pipe is regular pipe NPS (Inner diameter) of 1 1/4". The outer diameter is 1.66". The pipe is thin. Approximately 0.2 inches (0.2").
 
No. I am in the US. The pipe is regular pipe NPS (Inner diameter) of 1 1/4". The outer diameter is 1.66". The pipe is thin. Approximately 0.2 inches (0.2").
Sounds like the pipe isn`t suitable for thread cutting.
 

Reply to Die Size For Pipe Threading in the Plumbing Forum | Plumbing Advice area at PlumbersForums.net

Creating content since 2001. Untold Media.

OFFICIAL SPONSORS

OFFICIAL SPONSORS

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock