Discuss hilka tools, stillsons in the Plumbing Jobs | The Job-board area at PlumbersForums.net
W
Welder
I remember going for an interview as a rep for Hilka in 1974... 
They were up and coming then.
Good tools indeed used to use their socket sets when working on cars.
They were up and coming then.
Good tools indeed used to use their socket sets when working on cars.
- Messages
- 8,642
I used to use their gear years ago , I would have thought you would be ok with some 18” stilsons , do you work on the rigs lol
- Messages
- 8,642
Oil rig lol
Reply to hilka tools, stillsons in the Plumbing Jobs | The Job-board area at PlumbersForums.net
Similar plumbing topics
Hi I am trying to replace my bathroom tap with a new one, I am trying to remove the existing rusty flexible tap connectors from this bit of 22mm copper pipe.
But this thing is not budging at all its like its welded or super glued on, I am using some water pliers on both points here but its not...
Hi,
My boiler, which is 3 years old, has stopped working and it turns out it was the fuse.
I had an engineer resolve the issue, but when I turned the boiler off then back on it stopped working.
The fuse that was used was anF2AL250V, that's .2A
Should it have been an F2AH....?
Also, is it 2A...
Morning all,
I recently changed the washers on my kitchen mixer tap due to it dripping, I reseated it using a tool but it's still dripping. I have had another go today and on closer inspection of the seat it appears to have a hairline crack. Can this be repaired or do I change them completely...
Had a collapsed/cracked collar on the 90deg angled piece that my soil pipe sits in which is leaking water so has needed replacing.
Access has been through the outside wall to inside as the soil pipe is internal and boxed in.
Now I was expecting the plumber to fit a ‘rest bend’ but a 90 degree...
i have 3 sottini toilets with a compact cistern.
It has an ideal standard dual flush mechanism. 2" entry
The ideal standard is poor quality in my opinion, I have replaced the washer and complete unit several times but it always leaks within a short time (between 0-18 months),
I would like to...
Creating content since 2001. Untold Media.
Newest Plumbing Threads
-
-
-
What constitutes a Commercial Appliance and thus a Commercial Kitchen?
- Started by FozzieBear
- Replies: 3
-
POTTERTON PROMAX 28 COMBI Boiler - Hot Water Issue
- Started by boiler101
- Replies: 4
-
Hole in copper pipe, solder under floor, T coupling & protection- Started by dreikher
- Replies: 0
-
-
-
-
-
-
-
-
-
Sewer pipe problems not sure about it- Started by sammie81116
- Replies: 3
-