Discuss Replace shower head and hose? Possible ? in the Bathrooms, Showers and Wetrooms area at PlumbersForums.net
UK
Got a bath which is just over 10 years old and the shower head needs replacing.
This photo shows the layout.
I appreciate that access will be required to do this and could be achieved from the adjacent room by cutting a hole in the wall.
I’m not sure what I would then see and in preparation I was wondering if anybody could give me any pointers
Thanks
Super Moderator
Staff member
S. Mod
Plumber
Gas Engineer
Subscribed
- Messages
- 34,386
- Solutions
- 2
Will be just a 1/2 male iron on the body of the tap with the shower hose and head attached to that easy job once you have access
Will be just a 1/2 male iron on the body of the tap with the shower hose and head attached to that easy job once you have access
So I need to access below the taps ? And not below where the shower hose goes ?
Super Moderator
Staff member
S. Mod
Plumber
Gas Engineer
Subscribed
- Messages
- 34,386
- Solutions
- 2
So I need to access below the taps ? And not below where the shower hose goes ?
Correct aslong as you can tape the other hose to the old one / use some elec rods to fish it back through etc
Reply to Replace shower head and hose? Possible ? in the Bathrooms, Showers and Wetrooms area at PlumbersForums.net