You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
gas hob
-
G
Is my gas burner an FSD problem or a thermocouple problem?
I am troubleshooting a gas hob where one burner is reluctant to light. When it is lit and I blow the flame out the FSD on that burner cuts off immediately, whereas the others take 5-10 seconds as normal. I have tested the thermoucouple for continuity and also some sort of mV output (when held...- Gary M
- Thread
- burner fsd gas hob testing thermocouple
- Replies: 2
- Forum: Gas Engineers Forum
-
D
Replacing gas hob with existing cooker hood inside hot zone
Hi, my gas hob needs replacing but I'm told first the existing cooker hood must be raised as it's 70cm instead of 75cm above gas hob as per new regulations. Is that right?- dasau29
- Thread
- cooker existing forum gas gas hob hob hot inside plumbing replacing zone
- Replies: 2
- Forum: Plumbing Zone
-
H
Heat Input Gas Hob
Hi, Just started doing my gas course and we went through on my course the calc for gas rates and working out heat input etc. I have just done a gas rate on my hob and it seems there is a discrepancy of 1 between my reading and the MI. Assuming the heat input figure in the MI is always in...- hayati
- Thread
- america gas gas hob gas rate heat heat input hob input usa
- Replies: 2
- Forum: USA Plumbers Advice