Any advice would be very welcome. We need to replace our toilet seat. The toilet and seat have no makes on them. On measurements it’s 34 width and 40 length d shape. I have been looking everywhere and can not find this size toilet seat at all. I have found one that looks very similar called...
Hello,
I’m having a bit of an issue trying to fit a mixer shower bar, the pipe centres are around 3/4mm too narrow! I’ve attached a photo below, is there a simple fitting I can by to narrow the pipe centres by a few mm?
Hi chaps. I have put this in the gas safe forum even though it's not to do with gas.
A friend bought a narrow boat that had an old LPG boiler in it. Apparently these are very expensive to run so he has been given advice by others to install a solid fuel back boiler.
Now the old set up was...
Fire needed: I have a fireplace opening that is 380mm wide by 500mm high. I have a gas safe plumber to fit a living flame type fire if I can find one small enough to fit it - Does anyone know of such a fire. It doesn't need to be anything fancy.
Alan_Jeans
Thread
existing
fireplace
fires
gas
gas fire
living
narrow
needed
opening
I have a decorative fireplace in my rented flat, (no actual heating just a metal cover) and behind it a large (pretty cavernous) stone space that leads up to the chimney. I want to block it up, as a lot of cold air is coming down (and heat escaping up) but am finding it difficult. I bought a...
Sorry for the double post, I had to register I think:
Hi. I need to replace a broken bath mixer/shower tap but the gap between the pillars is 150mm and all the ones I find are 180 unless they are wall mounted which mine isn't. Any suggestions where I can get this size? Or any suggestions what I...
Apparently, we have a copper soil pipe with a diameter of approx 900 mm. We are installing a new shower and need to attach waste to the soil pipe, but due to it being made of copper, ii understand that will not be possible. Is there a way to cut the pipe take out a section and insert a plastic...
HI
We had a vey small room downstairs and looking for an electric towel radiator (does not matter if its chrome white or any other colour) the size needs to be between 200mm wide or 250mm wide here and here , i have found one but not sure how to convert it to electric, does any standard towel...
arasca
Thread
cheap
chrome
electric
narrow
radiator
towel
towel radiator
I have just taken on a house with RT212 TVR's fitted. They all work except one.
I have tried bleeding the rad but it is still cold.
I have tried removing the TRV top in order to try and release the pin. However, the pin seems to be raised (out) and with pliers I cannot move the pin in or out...
Question for you all, What is the deal using a condensing pipe to pump in up through the attic out into the guttering? Previous companies weve worked for on the Eaga/Hees Scheme have requested we do that and The current company says its not allowed. is it allowed and are the company being petty?
Hi,
Has anyone got a source, or know of what to use for internal baffle for vertical column radiators?
I'm re-doing my house and am installing vertical column rads to free up a lot of essential wall space. I'm worried that the water will shoot straight across the bottom tappings rather than...
I finished my bathroom - Now Shower room upgrade and toilet replacement over 6 months ago.
My next job was to replace the two header tanks and F&E tank in the loft. All galvanised tanks and 45 years old. As I am suffering with arthritis I thought 'to hell with it - get a man in. Arranged for...
Good Evening,
I have a Canray 5 boiler to heat both my hot water and central heating and has been installed for 5 years.
In past 2 days, the radiators have been cold despite the controller on wall showing heating is on, but, no noise etc…from boiler as you would expect if it was on. On...
amarner
Thread
arial
boiler
central
central heating system
narrow
oil
valve
water
...sort of. What's actually happened is I've fitted a TRV to a rad in my house. However the (sorry for lack of technical terms) connection from the valve to the rad is shorter than that which came off.
I managed to get the two vertical pipes onto the rad with the shorter 'bit' but the vertical...
Doobs Too
Thread
air
leak
merchants
narrow
pipes
plumbers
radiator
slightly
tools
trv
valve
website
work
Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.