ducting

We moved into a house with a gas Aga (I think converted from oil). The extraction pipe is fitted against and runs through an external wall, then up the outside of the external wall. The ducting pipe circumference is about 32cm, so about 10cm diameter. There is no extractor fan in the kitchen. We...

Morning, Im in a top floor tenement flat with access to the attic space. I have a combi boiler with flue that emits vertically up through the roof. My kitchen is situated internally with no easy access to an external wall. Could I fit a kitchen extractor that ducts vertically then right angles...

Hi guys, organising a new water supply to my property, specs require a seal between the MDPE 25mm pipe and 50/63mm ducting, can't use builders foam and i can't find a product for this (severn trent shows what looks like a rubber reducing seal but i can't find it on any site

Hi all. Does anyone have a manufactured system they use or make up their own out of plywood? Seen some ducts in BES but at £16 + vat for 3 metre is expensive and then you need to cut the ply top. Can kuterlex plastic coated copper pipe be buried in the screed without insulation or ducting...

Hi all, Looking for advice on the ventillation of the Bosch Greenstar i System Boilers. I've had one fitted into a new home I've purchased and the developer missed a course of bricks out so the ceiling is too low to install a vent to the outside. The boiler is in a small room (2m x 1x1.8m x...

Hi, I am renovating a house, and when I had a water meter fitted I took the opportunity to replace the lead supply pipe. It's only a short 2 meter run from the meter to the kitchen and I managed to source some 25mm MDPE pipe by asking a builder for any offcuts they had lying around at a...

Hi have got to price for fitting a couple of radiators in an extension, which will have a concrete base. I want to run the pipework in trunking, set in the base, can anyone suggest a supplier ? Have tried my usual merchants and they dont do it cheers

Wonder if anyone can help? Replacing lead water pipe and have spoken to water board who are not very helpful and have told us to dig the trench etc and call once done for them to inspect. Cannot get any other advice from them!! What is classed as suitable ducting for the mdpe pipe to be put...

Can this be done ? Cant go any other way ! Its a under-staires toilet ? Can i go down under the floor with rigid ducting and to a air brick outside ? Its only a toilet and a sink in there !

Want to place flat 220mm ducting along the top left hand corner of this picture (where it says 2.5 metres) to go to the outside wall, my question is how would i connect the ducting from the chimney bit from the cooker hood to the flat ducting so its flush along the length of the wall. The cooker...

Hi I've been away for a few weeks but when i got back home i noticed these squiggly marks near the extractor fan in my upstairs en-suite...obviously they look like water marks. Could someone tell me what this is likely to indicate before i get the plumber in? (i'm hopeless at DIY!). The property...

Hi There, Can anyone offer advice or information regarding Warm Air Heating systems within the home? I am currently looking at homes to buy, and came across a home built in the 1970s with this system, but I know very little about them. Pros and Cons? any dangers etc? Any advice is greatly...

i have a job in a bungalow where i need to move 2 radiators to other side of rooms. all the pipes are in pipe ducts with plywood covering pipes. i need to chase out the concrete floor to where the new rads will be situated, does anyone know of any trunking or ducting i can use.i have looked in...

Hi, i need some advice on where i should run the gas pipe inside a flat. it will be lpg gas coming underground into the property via a yellow plastic pipe and terminating in the boiler cupboard which is at the far end of the flat and the kitchen is at the other end of the flat. i need to...